ramips: add support for the HNET C108
The HNET C108 (http://www.szhwtech88.com/Product-product-cid-100-id-4374.html) is a mifi based on MT7602A, which has the following specifications: * CPU: MT7620A * 1x 10/100Mbps Ethernet. * 16 MB Flash. * 64 MB RAM. * 1x USB 2.0 port. Only power is connected, this port is meant for charging other devices. * 1x mini-PCIe slots. * 1x SIM slots. * 1x 2.4Ghz WIFI. * 1x button. * 6000 mAh battery. * 5x controllable LEDs. Works: * Wifi. * Switch. * mini-PCIe slot. Only tested with a USB device (a modem). * SIM slot. * Sysupgrade. * Button (reset). Not working (also applies to the factory firmware): * Wifi LED. It is always switched on, there is no relation to the up/down state or activity of the wireless interface. Not tested: * SD card reader. Notes: * The C108 has no dedicated status LED. I therefore set the LAN LED as status LED. Installation: The router comes pre-installed with OpenWRT, including a variant of Luci. The initial firmware install can be done through this UI, following normal procedure. I.e., access the UI and update the firmware using the sysupgrade-image. Remember to select that you do not want to keep existing settings. Recovery: If you brick the device, the C108 supports recovery using TFTP. Keep the reset button pressed for ~5sec when booting to trigger TFTP. Set the address of the network interface on your machine to 10.10.10.3/24, and rename your image file to Kernal.bin. Signed-off-by: Kristian Evensen <kristian.evensen@gmail.com>
This commit is contained in:
parent
096dff8fcd
commit
80829022b0
7 changed files with 197 additions and 0 deletions
|
@ -82,6 +82,10 @@ broadway)
|
|||
set_usb_led "$board:red:diskmounted"
|
||||
set_wifi_led "$board:red:wps_active"
|
||||
;;
|
||||
c108)
|
||||
ucidef_set_led_netdev "lan" "lan" "$board:green:lan" "eth0"
|
||||
ucidef_set_led_netdev "modem" "modem" "$board:green:modem" "wwan0"
|
||||
;;
|
||||
c20i)
|
||||
ucidef_set_led_switch "lan" "lan" "$board:blue:lan" "switch0" "0x1e"
|
||||
ucidef_set_led_switch "wan" "wan" "$board:blue:wan" "switch0" "0x01"
|
||||
|
|
|
@ -217,6 +217,7 @@ ramips_setup_interfaces()
|
|||
ucidef_add_switch "switch0" \
|
||||
"1:lan" "2:lan" "3:lan" "4:lan" "0:wan" "9@eth0"
|
||||
;;
|
||||
c108|\
|
||||
cf-wr800n)
|
||||
ucidef_add_switch "switch0" \
|
||||
"4:lan" "6t@eth0"
|
||||
|
|
|
@ -103,6 +103,9 @@ get_status_led() {
|
|||
wrh-300cr)
|
||||
status_led="$board:green:wps"
|
||||
;;
|
||||
c108)
|
||||
status_led="$board:green:lan"
|
||||
;;
|
||||
cf-wr800n|\
|
||||
psg1208)
|
||||
status_led="$board:white:wps"
|
||||
|
|
|
@ -85,6 +85,9 @@ ramips_board_detect() {
|
|||
*"Broadway")
|
||||
name="broadway"
|
||||
;;
|
||||
*"C108")
|
||||
name="c108"
|
||||
;;
|
||||
*"C20i")
|
||||
name="c20i"
|
||||
;;
|
||||
|
|
|
@ -29,6 +29,7 @@ platform_check_image() {
|
|||
awm002-evb-8M|\
|
||||
bc2|\
|
||||
broadway|\
|
||||
c108|\
|
||||
carambola|\
|
||||
cf-wr800n|\
|
||||
cs-qr10|\
|
||||
|
|
177
target/linux/ramips/dts/C108.dts
Normal file
177
target/linux/ramips/dts/C108.dts
Normal file
|
@ -0,0 +1,177 @@
|
|||
/*
|
||||
* BSD LICENSE
|
||||
*
|
||||
* Copyright(c) 2017 Kristian Evensen <kristian.evensen@gmail.com>.
|
||||
* All rights reserved.
|
||||
*
|
||||
* Redistribution and use in source and binary forms, with or without
|
||||
* modification, are permitted provided that the following conditions
|
||||
* are met:
|
||||
*
|
||||
* * Redistributions of source code must retain the above copyright
|
||||
* notice, this list of conditions and the following disclaimer.
|
||||
* * Redistributions in binary form must reproduce the above copyright
|
||||
* notice, this list of conditions and the following disclaimer in
|
||||
* the documentation and/or other materials provided with the
|
||||
* distribution.
|
||||
* * Neither the name of Broadcom Corporation nor the names of its
|
||||
* contributors may be used to endorse or promote products derived
|
||||
* from this software without specific prior written permission.
|
||||
*
|
||||
* THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS
|
||||
* "AS IS" AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT
|
||||
* LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR
|
||||
* A PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE COPYRIGHT
|
||||
* OWNER OR CONTRIBUTORS BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL,
|
||||
* SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT
|
||||
* LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE,
|
||||
* DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY
|
||||
* THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT
|
||||
* (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE
|
||||
* OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.
|
||||
*/
|
||||
|
||||
/dts-v1/;
|
||||
|
||||
#include "mt7620a.dtsi"
|
||||
|
||||
#include <dt-bindings/gpio/gpio.h>
|
||||
#include <dt-bindings/input/input.h>
|
||||
|
||||
/ {
|
||||
compatible = "hnet,c108", "ralink,mt7620a-soc";
|
||||
model = "HNET C108";
|
||||
|
||||
chosen {
|
||||
bootargs = "console=ttyS0,115200";
|
||||
};
|
||||
|
||||
gpio-export {
|
||||
compatible = "gpio-export";
|
||||
#size-cells = <0>;
|
||||
|
||||
power_modem {
|
||||
gpio-export,name = "power_modem";
|
||||
gpio-export,output = <1>;
|
||||
gpios = <&gpio2 2 GPIO_ACTIVE_HIGH>;
|
||||
};
|
||||
};
|
||||
|
||||
gpio-leds {
|
||||
compatible = "gpio-leds";
|
||||
|
||||
sdcard {
|
||||
label = "c108:green:sdcard";
|
||||
gpios = <&gpio0 13 GPIO_ACTIVE_HIGH>;
|
||||
};
|
||||
|
||||
modem_green {
|
||||
label = "c108:green:modem";
|
||||
gpios = <&gpio1 14 GPIO_ACTIVE_LOW>;
|
||||
};
|
||||
|
||||
modem_red {
|
||||
label = "c108:red:modem";
|
||||
gpios = <&gpio1 15 GPIO_ACTIVE_LOW>;
|
||||
};
|
||||
|
||||
lan_red {
|
||||
label = "c108:red:lan";
|
||||
gpios = <&gpio2 3 GPIO_ACTIVE_HIGH>;
|
||||
};
|
||||
|
||||
lan_green {
|
||||
label = "c108:green:lan";
|
||||
gpios = <&gpio2 4 GPIO_ACTIVE_HIGH>;
|
||||
};
|
||||
};
|
||||
|
||||
gpio-keys-polled {
|
||||
compatible = "gpio-keys-polled";
|
||||
#address-cells = <1>;
|
||||
#size-cells = <0>;
|
||||
poll-interval = <20>;
|
||||
|
||||
reset {
|
||||
label = "reset";
|
||||
gpios = <&gpio0 1 GPIO_ACTIVE_LOW>;
|
||||
linux,code = <KEY_RESTART>;
|
||||
};
|
||||
};
|
||||
};
|
||||
|
||||
&gpio1 {
|
||||
status = "okay";
|
||||
};
|
||||
|
||||
&gpio2 {
|
||||
status = "okay";
|
||||
};
|
||||
|
||||
&spi0 {
|
||||
status = "okay";
|
||||
|
||||
en25q128@0 {
|
||||
#address-cells = <1>;
|
||||
#size-cells = <1>;
|
||||
compatible = "jedec,spi-nor";
|
||||
reg = <0>;
|
||||
spi-max-frequency = <10000000>;
|
||||
|
||||
partition@0 {
|
||||
label = "u-boot";
|
||||
reg = <0x0 0x30000>;
|
||||
read-only;
|
||||
};
|
||||
|
||||
partition@30000 {
|
||||
label = "u-boot-env";
|
||||
reg = <0x30000 0x10000>;
|
||||
read-only;
|
||||
};
|
||||
|
||||
factory: partition@40000 {
|
||||
label = "factory";
|
||||
reg = <0x40000 0x10000>;
|
||||
read-only;
|
||||
};
|
||||
|
||||
partition@50000 {
|
||||
label = "firmware";
|
||||
reg = <0x50000 0xfb0000>;
|
||||
};
|
||||
};
|
||||
};
|
||||
|
||||
&sdhci {
|
||||
status = "okay";
|
||||
};
|
||||
|
||||
&ehci {
|
||||
status = "okay";
|
||||
};
|
||||
|
||||
&ohci {
|
||||
status = "okay";
|
||||
};
|
||||
|
||||
ðernet {
|
||||
mtd-mac-address = <&factory 0x28>;
|
||||
};
|
||||
|
||||
&wmac {
|
||||
ralink,mtd-eeprom = <&factory 0>;
|
||||
};
|
||||
|
||||
&pinctrl {
|
||||
state_default: pinctrl0 {
|
||||
default {
|
||||
ralink,group = "i2c", "uartf", "spi refclk", "ephy";
|
||||
ralink,function = "gpio";
|
||||
};
|
||||
};
|
||||
};
|
||||
|
||||
&pcie {
|
||||
status = "okay";
|
||||
};
|
|
@ -62,6 +62,14 @@ define Device/ArcherMR200
|
|||
endef
|
||||
TARGET_DEVICES += ArcherMR200
|
||||
|
||||
define Device/c108
|
||||
DTS := C108
|
||||
IMAGE_SIZE := 16777216
|
||||
DEVICE_TITLE := HNET C108
|
||||
DEVICE_PACKAGES := kmod-usb2 kmod-usb-ohci kmod-sdhci-mt7620
|
||||
endef
|
||||
TARGET_DEVICES += c108
|
||||
|
||||
define Device/cf-wr800n
|
||||
DTS := CF-WR800N
|
||||
DEVICE_TITLE := Comfast CF-WR800N
|
||||
|
|
Loading…
Reference in a new issue