Commit graph

1217 commits

Author SHA1 Message Date
Gabor Juhos
368bbc510b ar71xx: enable has_gbit flag on AR724{0,1}
SVN-Revision: 29026
2011-11-13 17:36:36 +00:00
Gabor Juhos
15d7016c9f ar71xx: fixup onboard PCIe chip registration on the DB120 board
SVN-Revision: 29022
2011-11-13 12:48:03 +00:00
Gabor Juhos
f623066e60 ar71xx: drop DB120_WMAC_MAC_OFFSET, it is not needed
SVN-Revision: 29021
2011-11-13 12:48:01 +00:00
Gabor Juhos
d2316b2a45 ar71xx: ag71xx: add support for getting switch port link status
SVN-Revision: 29017
2011-11-13 11:27:04 +00:00
Gabor Juhos
d0db89133c ar71xx: remove mii_ctrl resources of the ethernet devices
SVN-Revision: 29016
2011-11-13 11:27:03 +00:00
Gabor Juhos
34015ed6e8 ar71xx: ag71xx: remove unused mii_ctrl field from struct ag71xx
SVN-Revision: 29015
2011-11-13 11:27:01 +00:00
Gabor Juhos
2d882cff23 ar71xx: ag71xx: remove unused mii_cfg related functions and defines
SVN-Revision: 29014
2011-11-13 11:27:00 +00:00
Gabor Juhos
538a9493b9 ar71xx: set MII interface speed from the set_speed callbacks
SVN-Revision: 29013
2011-11-13 11:26:59 +00:00
Gabor Juhos
93cd46be13 ar71xx: rename set_pll callback to set_speed in ag71xx_platform_data
Also rename the corresponding callback functions.

SVN-Revision: 29012
2011-11-13 11:26:57 +00:00
Gabor Juhos
9579bb4267 ar71xx: ag71xx: remove MII interface setup code
SVN-Revision: 29011
2011-11-13 11:26:56 +00:00
Gabor Juhos
da64ce8603 ar71xx: configure MII interface type from ar71xx_setup_phy_if_mode
SVN-Revision: 29010
2011-11-13 11:26:54 +00:00
Gabor Juhos
0112153a0e ar71xx: fix occasional kernel hangs during boot on AR934x
The patch taken from the linux-mips mailing list.

The Kernel hangs occasionally during boot after
"Calibrating delay loop..". This is caused by the
c0_compare_int_usable() routine in cevt-r4k.c
returning false which causes the system to disable
the timer and hang later. The false return happens
because the routine is using a series of four calls
to irq_disable_hazard() as a delay while it waits
for the timer changes to propagate to the cp0 cause
register. On newer MIPS cores, like the 74K, the
series of irq_disable_hazard() calls turn into ehb
instructions and can take as little as a few clock
ticks for all 4 instructions. This is not enough of
a delay, so the routine thinks the timer is not
working.

This fix uses up to a max number of cycle counter
ticks for the delay and uses back_to_back_c0_hazard()
instead of irq_disable_hazard() to handle the hazard
condition between cp0 writes and cp0 reads.

SVN-Revision: 29009
2011-11-13 11:26:52 +00:00
Gabor Juhos
1afc76ea13 ar71xx: refresh kernel patches
SVN-Revision: 29008
2011-11-13 11:26:51 +00:00
Gabor Juhos
5ad763075e ar71xx: use the button for WPS control on the DB120
SVN-Revision: 28990
2011-11-12 12:50:20 +00:00
Gabor Juhos
4555be2bec ar71xx: register the second ethernet interface on the DB120 board
SVN-Revision: 28989
2011-11-12 12:50:19 +00:00
Gabor Juhos
368c6605a0 ar71xx: implement SoC specific phy interface setup
SVN-Revision: 28988
2011-11-12 12:50:18 +00:00
Gabor Juhos
21d317b9cc ar71xx: move phy interface setup into a separate function
SVN-Revision: 28987
2011-11-12 12:50:16 +00:00
Gabor Juhos
aff0c84ffa ar71xx: register both MDIO bus on the DB120 board
SVN-Revision: 28986
2011-11-12 12:09:59 +00:00
Gabor Juhos
b144249108 ar71xx: add AR934X specific MDIO registration code
SVN-Revision: 28985
2011-11-12 12:09:56 +00:00
Gabor Juhos
f835106c8c ar71xx: add a secondary mdio bus
SVN-Revision: 28984
2011-11-12 12:09:54 +00:00
Gabor Juhos
90a42da270 ar71xx: rename ar71xx_mdio_* structures to ar71xx_mdio0_*
SVN-Revision: 28983
2011-11-12 12:09:50 +00:00
Gabor Juhos
9daa2149fd ar71xx: add an id argument to ar71xx_add_device_mdio
SVN-Revision: 28982
2011-11-12 12:09:48 +00:00
Gabor Juhos
b07b687aec ar71xx: pass netdev and miidev pointer to ar71xx_add_device_dsa
SVN-Revision: 28981
2011-11-12 12:09:42 +00:00
Gabor Juhos
a9216bb76e ar71xx: add AR934x specific USB setup
SVN-Revision: 28980
2011-11-12 10:54:20 +00:00
Gabor Juhos
346e44105a ar71xx: register the first ethernet interface on the DB120 board
SVN-Revision: 28979
2011-11-12 10:54:18 +00:00
Gabor Juhos
b1ba5e2f3d ar71xx: allow to register ethernet interfaces for AR934X
SVN-Revision: 28978
2011-11-12 10:54:17 +00:00
Gabor Juhos
2f9e535e89 ar71xx: ag71xx: use fixed link parameters if the mii bus is not registered
SVN-Revision: 28977
2011-11-12 10:54:16 +00:00
Gabor Juhos
e962b07c8b ar71xx: add AR934X specific bootstrap and reset register bits
SVN-Revision: 28976
2011-11-12 10:54:15 +00:00
Gabor Juhos
d461fdd519 ar71xx: add diag support for the DB120 board
SVN-Revision: 28975
2011-11-12 10:54:10 +00:00
Gabor Juhos
d8db8e94c8 ar71xx: fix GPIO direction setup for AR934x
SVN-Revision: 28974
2011-11-12 10:54:09 +00:00
Gabor Juhos
43e993e5f5 ar71xx: fix AR934X clock frequency calculation
SVN-Revision: 28973
2011-11-12 10:54:08 +00:00
Gabor Juhos
8687fc3e41 ar71xx: generate ubootenv from uci-defaults instead of providing defconfig
I noticed most of /etc/defconfig was replaced by /etc/uci-defaults, which is
indeed much nicer. So I moved over ubootenv from having a defconfig-entry to
also be generated from uci-defaults.

Signed-off-by: Daniel Golle <dgolle@allnet.de>

SVN-Revision: 28971
2011-11-12 10:54:04 +00:00
Felix Fietkau
7a2efd8c28 ar71xx: remove dead code
SVN-Revision: 28851
2011-11-08 00:33:20 +00:00
Felix Fietkau
94309039b7 ar71xx: on ar7240, exclude ports from their own port vlan destination mask
SVN-Revision: 28850
2011-11-08 00:33:15 +00:00
Gabor Juhos
87704b8078 ar71xx: create TL-WA901ND network config from uci-defaults
SVN-Revision: 28833
2011-11-07 21:44:24 +00:00
Gabor Juhos
09fdfa444f ar71xx: create ALL0258N network config from uci-defaults
SVN-Revision: 28832
2011-11-07 21:44:23 +00:00
Gabor Juhos
63348f5fed ar71xx: create NBG{460N,550N,550NH} network config from uci-defaults
SVN-Revision: 28831
2011-11-07 21:44:20 +00:00
Gabor Juhos
c3692c8331 ar71xx: create WZR-HP-G300NH network config from uci-defaults
SVN-Revision: 28830
2011-11-07 21:44:17 +00:00
Gabor Juhos
ee1a07a11d ar71xx: create RB-493G network config from uci-defaults
SVN-Revision: 28829
2011-11-07 21:44:12 +00:00
Gabor Juhos
d82d063d81 ar71xx: create TL-WR1043ND network config from uci-defaults
SVN-Revision: 28828
2011-11-07 21:44:11 +00:00
Gabor Juhos
68be590894 ar71xx: create WRT160NL network config from uci-defaults
SVN-Revision: 28827
2011-11-07 21:44:09 +00:00
Gabor Juhos
83901e47c9 ar71xx: create PB92 network config from uci-defaults
SVN-Revision: 28826
2011-11-07 21:44:08 +00:00
Gabor Juhos
22ab9fc9ad ar71xx: create DIR-825-B1 network config from uci-defaults
SVN-Revision: 28825
2011-11-07 21:44:07 +00:00
Gabor Juhos
e866ba5753 ar71xx: create TL-WR{841N-v1,941ND} network config from uci-defaults
SVN-Revision: 28824
2011-11-07 21:44:03 +00:00
Gabor Juhos
9298c7afe5 ar71xx: create RB-450 network config from uci-defaults
SVN-Revision: 28823
2011-11-07 21:44:02 +00:00
Gabor Juhos
ac256f97bd ar71xx: create RB-450G, RouterStation Pro network config from uci-defaults
SVN-Revision: 28822
2011-11-07 21:44:01 +00:00
Gabor Juhos
944ac3f6cf ar71xx: create RB-433{,U} network config from uci defaults
SVN-Revision: 28821
2011-11-07 21:43:58 +00:00
Gabor Juhos
6e8390ae6c ar71xx: create even more network configs from the uci-defaults script
Create the default network configuration dynamically for the
AR724x/AR9331 boards. Some other boards are using the same
configuration, so convert those as well.

SVN-Revision: 28820
2011-11-07 21:43:56 +00:00
Gabor Juhos
b62560413a ar71xx: create more network configs from the uci-defaults script
Create the default network configuration dynamically for the boards with
swapped eth0, eth1 interfaces.

SVN-Revision: 28819
2011-11-07 21:43:54 +00:00
Gabor Juhos
6c92b26bac ar71xx: create a bunch of network configs from the uci-defaults script
Create the default network configuration dynamically for the boards with
a single ethernet interface.

SVN-Revision: 28818
2011-11-07 21:43:52 +00:00