57 lines
1.8 KiB
Python
57 lines
1.8 KiB
Python
"""
|
|
This example shows connecting to the PN532 with I2C (requires clock
|
|
stretching support), SPI, or UART. SPI is best, it uses the most pins but
|
|
is the most reliable and universally supported.
|
|
After initialization, try waving various 13.56MHz RFID cards over it!
|
|
"""
|
|
|
|
import board
|
|
import busio
|
|
from digitalio import DigitalInOut
|
|
|
|
#
|
|
# NOTE: pick the import that matches the interface being used
|
|
#
|
|
from adafruit_pn532.i2c import PN532_I2C
|
|
|
|
# from adafruit_pn532.spi import PN532_SPI
|
|
# from adafruit_pn532.uart import PN532_UART
|
|
|
|
# I2C connection:
|
|
i2c = busio.I2C(board.SCL, board.SDA)
|
|
|
|
# Non-hardware
|
|
# pn532 = PN532_I2C(i2c, debug=False)
|
|
|
|
# With I2C, we recommend connecting RSTPD_N (reset) to a digital pin for manual
|
|
# harware reset
|
|
reset_pin = DigitalInOut(board.D6)
|
|
# On Raspberry Pi, you must also connect a pin to P32 "H_Request" for hardware
|
|
# wakeup! this means we don't need to do the I2C clock-stretch thing
|
|
req_pin = DigitalInOut(board.D12)
|
|
pn532 = PN532_I2C(i2c, debug=False, reset=reset_pin, req=req_pin)
|
|
|
|
# SPI connection:
|
|
# spi = busio.SPI(board.SCK, board.MOSI, board.MISO)
|
|
# cs_pin = DigitalInOut(board.D5)
|
|
# pn532 = PN532_SPI(spi, cs_pin, debug=False)
|
|
|
|
# UART connection
|
|
# uart = busio.UART(board.TX, board.RX, baudrate=115200, timeout=100)
|
|
# pn532 = PN532_UART(uart, debug=False)
|
|
|
|
ic, ver, rev, support = pn532.firmware_version
|
|
print("Found PN532 with firmware version: {0}.{1}".format(ver, rev))
|
|
|
|
# Configure PN532 to communicate with MiFare cards
|
|
pn532.SAM_configuration()
|
|
|
|
print("Waiting for RFID/NFC card...")
|
|
while True:
|
|
# Check if a card is available to read
|
|
uid = pn532.read_passive_target(timeout=0.5)
|
|
print(".", end="")
|
|
# Try again if no card is available.
|
|
if uid is None:
|
|
continue
|
|
print("Found card with UID:", [hex(i) for i in uid])
|