Hauke Mehrtens ca7f9638d5 broadcom-diag: support for the WNDR3700v3 ... I recently picked up a WNDR3700 to put OpenWRT on, and only after tearing into the box did I find it was one of the v3 boards, with poor OpenWRT support. This patch should add the board detection and LED/button control to the broadcom-diag module, and should generate a netgear .chk image that the bootloader and stock firmware will accept. The changes to the broadcom-diag module are more than a few lines because the WNDR3700v3 is driving its LEDs through an HC164 8-bit shift register. Signed-off-by: Owen Kirby <osk@exegin.com> SVN-Revision: 36482		2013-04-28 21:11:17 +00:00
..
imagebuilder	build: consistently use 'depends on' instead of 'depends'	2013-04-17 15:36:41 +00:00
linux	broadcom-diag: support for the WNDR3700v3	2013-04-28 21:11:17 +00:00
sdk	build: consistently use 'depends on' instead of 'depends'	2013-04-17 15:36:41 +00:00
toolchain	build: consistently use 'depends on' instead of 'depends'	2013-04-17 15:36:41 +00:00
Config.in	build: consistently use 'depends on' instead of 'depends'	2013-04-17 15:36:41 +00:00
Makefile	target: do not make target/*/install depend on target/*/compile - removes one redundant kernel build dir call on target/install	2012-06-06 17:24:05 +00:00