ca27b3d370
The Cisco ON100 device is a Kirkwood based router:
SoC: Marvell 88F6282 1600Mhz
SDRAM memory: 512MB DDR3 1333Mhz
Gigabit ethernet: 2x Marvell 88E1310 (over RGMII)
Flash memory: 512MB
2 bi-colour status LEDs (green/red)
1 Reset button
1 USB 2.0 port (on back)
1 SDIO slot (on back)
This commit adds a target profile of "Cisco Systems ON100" under the target
system "Marvell Kirkwood".
Flashing can be performed over tftp, once "dhcp" has been issued:
tftpboot ${loadaddr} lede-kirkwood-on100-squashfs-factory.bin
nand erase 0x0c0000 ${filesize}
nand write ${loadaddr} 0x0c0000 ${filesize}
Once flashed, set environment variables to boot:
setenv bootcmd nand read \${loadaddr} 0x0c0000 0x540000\; setenv bootargs
\; bootm
saveenv
Signed-off-by: Makoto Takeuchi <mak0@lxsys.co.uk>
49 lines
706 B
Bash
Executable file
49 lines
706 B
Bash
Executable file
#!/bin/sh
|
|
# Copyright (C) 2014 OpenWrt.org
|
|
|
|
. /lib/functions/leds.sh
|
|
. /lib/kirkwood.sh
|
|
|
|
get_status_led() {
|
|
case $(kirkwood_board_name) in
|
|
dockstar|\
|
|
goflexhome|\
|
|
goflexnet)
|
|
status_led="status:orange:fault"
|
|
;;
|
|
pogo_e02)
|
|
status_led="pogo_e02:orange:fault"
|
|
;;
|
|
linksys-audi)
|
|
status_led="audi:green:power"
|
|
;;
|
|
linksys-viper)
|
|
status_led="viper:white:health"
|
|
;;
|
|
nsa310b)
|
|
status_led="nsa310:green:sys"
|
|
;;
|
|
on100)
|
|
status_led="on100:green:health"
|
|
;;
|
|
esac
|
|
}
|
|
|
|
set_state() {
|
|
get_status_led
|
|
|
|
case "$1" in
|
|
preinit)
|
|
status_led_blink_preinit
|
|
;;
|
|
failsafe)
|
|
status_led_blink_failsafe
|
|
;;
|
|
preinit_regular)
|
|
status_led_blink_preinit_regular
|
|
;;
|
|
done)
|
|
status_led_on
|
|
;;
|
|
esac
|
|
}
|