Felix Fietkau c75a0e86b1 ar71xx: add mask and shift for RXD/RDV bits in AR934X register file ... The commit r38948 ("ag71xx: add F1E specific feature bit definitions to AR934X register file") introduced definitions for some bits in the RDV/RXD part of the ETH_CFG register of AR934x. These are incomplete because ETH_RXDV_DELAY is specified as 17:16 and ETH_RXD_DELAY is specified 15:14. The original commit only specified the lower bits. The upper bits also have to be unset when the lower bits should only be set. Signed-off-by: Sven Eckelmann <sven@open-mesh.com> SVN-Revision: 45522		2015-04-20 15:00:41 +00:00
..
base-files	ar71xx: enable LEDs on Hornet-UB X2	2015-04-09 10:32:08 +00:00
files	ar71xx: Remove TX/RX delay from pll_1000 for OM5P-AN	2015-04-20 15:00:20 +00:00
generic	ar71xx: adjust OM5P profile for the OpenMesh OM5P-AN board	2015-03-17 09:43:56 +00:00
image	Revert "ar71xx/image: move TPLINK-LZMA image to new build code" (r45490)	2015-04-19 19:19:12 +00:00
mikrotik	ar71xx: add initial support for RB911G-5HPacD	2015-04-07 20:04:03 +00:00
nand	Netgear R6100 support	2014-11-26 08:28:22 +00:00
patches-3.18	ar71xx: add mask and shift for RXD/RDV bits in AR934X register file	2015-04-20 15:00:41 +00:00
base-files.mk	ar71xx: drop procd_init console hack	2013-06-21 16:53:11 +00:00
config-3.18	ar71xx: Enable AT803X_PHY to set special flags	2015-04-14 19:00:57 +00:00
Makefile	ar71xx: make v3.18 default	2015-02-17 14:33:29 +00:00
modules.mk	ar71xx: always enable hw ecc support for the ar934x-nfc module	2013-11-01 18:33:18 +00:00