openwrtv4/target/linux/ipq806x
Sebastian Quilitz ae79c41286 ipq806x: add support for TP-Link Archer VR2600v
This router is similar to the C2600. Ethernet on WAN + LAN, switch,
sysupgrade, LEDs, buttons and WiFi on 2G + 5G do work. The xDSL modem
and the POTS/DECT interface are not supported yet.

It is not possible to flash LEDE via the TP-Link webinterface. The
image need to be signed. The first 0x200 bytes of the image is the
TP-Link header including the signature. The signature is not validated
by the bootloader. The LEDE image is zeroed in this area.

To install LEDE it is necessary to solder a four pin header to JP2.
Connect a serial interface to this header and interrupt the autostart
of kernel. Transfer the sysupgrade image via TFTP and write it to the
serial flash at 0x320000.

Signed-off-by: Sebastian Quilitz <zeraphim@x-pantion.de>
2016-11-24 22:37:40 +01:00
..
base-files ipq806x: add support for TP-Link Archer VR2600v 2016-11-24 22:37:40 +01:00
files/arch/arm/boot/dts ipq806x: add support for TP-Link Archer VR2600v 2016-11-24 22:37:40 +01:00
image ipq806x: add support for TP-Link Archer VR2600v 2016-11-24 22:37:40 +01:00
patches-4.4 ipq806x: switch to upstream usb driver and backport fixes 2016-11-21 09:58:42 +01:00
profiles ipq806x: enable ath10k firmware for 988x, 99x0 and 9984 by default 2016-07-04 11:41:32 +02:00
config-4.4 ipq806x: enable swconfig LED support 2016-11-21 10:04:55 +01:00
Makefile ipq806x: switch to upstream usb driver and backport fixes 2016-11-21 09:58:42 +01:00
modules.mk ipq806x: switch to upstream usb driver and backport fixes 2016-11-21 09:58:42 +01:00