openwrtv4/package/broadcom-diag
Hauke Mehrtens ca7f9638d5 broadcom-diag: support for the WNDR3700v3
I recently picked up a WNDR3700 to put OpenWRT on, and only after tearing into the box did I find it
was one of the v3 boards, with poor OpenWRT support. This patch should add the board detection and
LED/button control to the broadcom-diag module, and should generate a netgear .chk image that the
bootloader and stock firmware will accept.

The changes to the broadcom-diag module are more than a few lines because the WNDR3700v3 is driving
its LEDs through an HC164 8-bit shift register.

Signed-off-by: Owen Kirby <osk@exegin.com>

SVN-Revision: 36482
2013-04-28 21:11:17 +00:00
..
src broadcom-diag: support for the WNDR3700v3 2013-04-28 21:11:17 +00:00
Makefile broadcom-diag: SimpleShare: expose power button as reset to the system, remove actual reset button - it's hardwired and will reset the SoC (#7928) 2010-09-13 01:35:39 +00:00