Jiawei Wang 9c500db896 ramips: fix used MAC addresses for Phicomm K2P ... The factory partition of the Phicomm K2P contains two MAC addresses. The lower MAC address is at offset 0xe006 and the higher one is at offset 0xe000. Use the lower MAC address as base mac-address which the switch driver increments by one for the second (wan) vlan. The MAC addresses are still inverted in contrast to the stock firmware where the lower MAC address is used for wan. But at least the use of a MAC address not intended/reserved for this particular board is fixed. Signed-off-by: Jiawei Wang <me@jwang.link>		2017-09-15 07:14:29 +02:00
..
imagebuilder	imagebuilder: don't rewrite package list output	2017-06-17 01:24:43 +02:00
linux	ramips: fix used MAC addresses for Phicomm K2P	2017-09-15 07:14:29 +02:00
sdk	build: get rid of host.mk	2017-02-26 13:31:44 +01:00
toolchain	build: get rid of host.mk	2017-02-26 13:31:44 +01:00
Config.in	kernel: allow selecting RTC drivers on targets without explicit RTC support	2017-05-02 14:33:58 +02:00
Makefile	build: make <subdir>/install opt-in, use it for target/ only	2017-02-09 13:51:35 +01:00