openwrtv4/target/linux/ipq806x
Sven Eckelmann 86e18f6706 ipq806x: add support for OpenMesh A42
* QCA IPQ401x
* 256 MB of RAM
* 32 MB of SPI NOR flash (s25fl256s1)
  - 2x 15 MB available; but one of the 15 MB regions is the recovery image
* 2T2R 2.4 GHz
  - QCA4019 hw1.0 (SoC)
  - requires special BDF in QCA4019/hw1.0/board-2.bin with
    bus=ahb,bmi-chip-id=0,bmi-board-id=16,variant=OM-A42
* 2T2R 5 GHz
  - QCA4019 hw1.0 (SoC)
  - requires special BDF in QCA4019/hw1.0/board-2.bin with
    bus=ahb,bmi-chip-id=0,bmi-board-id=17,variant=OM-A42
* multi-color LED (controlled via red/green/blue GPIOs)
* 1x button (reset; kmod-input-gpio-keys compatible)
* external watchdog
  - triggered GPIO
* 1x USB (xHCI)
* TTL pins are on board (arrow points to VCC, then follows: GND, TX, RX)
* 2x gigabit ethernet
* powered only via POE
  - 802.3af POE on Ethernet 1
  - 18-24v passive POE (mode B) on Ethernet 2

The tool ap51-flash (https://github.com/ap51-flash/ap51-flash) should be
used to transfer the factory image to the u-boot when the device boots up.

Signed-off-by: Sven Eckelmann <sven.eckelmann@open-mesh.com>
2018-01-13 08:00:14 +01:00
..
base-files ipq806x: add support for OpenMesh A42 2018-01-13 08:00:14 +01:00
files-4.9/arch/arm/boot/dts ipq806x: add support for OpenMesh A42 2018-01-13 08:00:14 +01:00
image ipq806x: add support for OpenMesh A42 2018-01-13 08:00:14 +01:00
patches-4.9 ipq806x: add support for OpenMesh A42 2018-01-13 08:00:14 +01:00
profiles ipq806x: enable ath10k firmware for 988x, 99x0 and 9984 by default 2016-07-04 11:41:32 +02:00
config-4.9 ipq806x: enable gpio watchdog support 2018-01-13 08:00:07 +01:00
Makefile ipq806x: set v4.9 as default 2017-03-22 09:45:18 +01:00
modules.mk Revert "ipq806x: make the dwc3 driver and required phy drivers built-in" 2017-03-23 08:29:44 +01:00