No description
513e8c583f
* Create defines for some magic values/masks. * Change vlan_id to u16, to allow VIDs > 255. * Add a range check to set_pvid as it isn't a VID, but the index in the vlan table. * Set the max VID to 4094, since 4095 is a reserved value and should not be used. * In mangle_rx replace the provided VID with the VID of the table entry of the port, not the index of the table. * In hw_apply, remove a redundant emptyness check (was already checked several lines above). * In no vlan mode do not set the ingress mode to secure, as there are no vlan table entries, but to use the port's destination masks. Otherwise the switch won't forward anything. * In read_status tell that the phy is up (taken from the rtl8306 driver). SVN-Revision: 20083 |
||
|---|---|---|
| docs | ||
| include | ||
| package | ||
| scripts | ||
| target | ||
| toolchain | ||
| tools | ||
| .gitignore | ||
| BSDmakefile | ||
| Config.in | ||
| feeds.conf.default | ||
| LICENSE | ||
| Makefile | ||
| README | ||
| rules.mk | ||
This is the buildsystem for the OpenWrt Linux distribution Please use "make menuconfig" to configure your appreciated configuration for the toolchain and firmware. You need to have installed gcc, binutils, patch, bzip2, flex, make, gettext, pkg-config, unzip, libz-dev and libc headers. Simply running 'make' will build your firmware. It will download all sources, build the cross-compile toolchain, the kernel and all choosen applications. You can use scripts/flashing/flash.sh for remotely updating your embedded system via tftp. The OpenWrt system is documented in docs/. You will need a LaTeX distribution and the tex4ht package to build the documentation. Type make -C docs/ to build it. Building your own firmware you need to have access to a Linux, BSD or MacOSX system. Cygwin will not be supported because of the lack of case sensitiveness. Sunshine! Your OpenWrt Project http://openwrt.org