openwrtv4

History

Felix Fietkau faabe8e8e6 malta: make eth0 the wan interface by default Many packages for OpenWrt currently assume that lan is the "internal" side of the network map, e.g. if installed, dnsmasq will hand out DHCP leases on lan, firewall will allow forwarding on lan. While at it, also configure a lan interface if eth1 exists. Signed-off-by: Yousong Zhou <yszhou4tech@gmail.com> SVN-Revision: 47326		2015-10-31 09:30:57 +00:00
..
base-files/etc	malta: make eth0 the wan interface by default	2015-10-31 09:30:57 +00:00
be	build: unify mips target cflags	2013-09-26 17:53:14 +00:00
be64	build: unify mips target cflags	2013-09-26 17:53:14 +00:00
image	build: Prevent more gzip timestamps	2015-07-14 09:57:45 +00:00
le	build: unify mips target cflags	2013-09-26 17:53:14 +00:00
le64	build: unify mips target cflags	2013-09-26 17:53:14 +00:00
patches	kernel: update 3.18 to 3.18.14	2015-05-21 19:32:46 +00:00
config-3.18	malta: disable the openwrt commandline hack	2015-08-30 12:18:05 +00:00
Makefile	malta: use as a default type device	2015-10-31 09:30:37 +00:00
README

README

This Malta target is intended to be used with the Qemu emulator. It can be used
to prototype an OpenWrt firmware for MIPS processors. One could also use it to
troubleshoot MIPS applications without access to real hardware.

To use the images built by OpenWrt with qemu, use the following commands:

For the little-endian image:
qemu-system-mipsel -kernel bin/malta/openwrt-malta-le-vmlinux-initramfs.elf -nographic -m 256

For the big-endian image:
qemu-system-mips -kernel bin/malta/openwrt-malta-be-vmlinux-initramfs.elf -nographic -m 256

and enjoy the system bootin.