openwrtv4/target/linux/ipq806x
Christian Lamparter 42b47f1b40 ipq806x: overhaul AVM FRITZ!box 4040 device-tree file
This patch aligns the device-tree file with the latest
guidelines.
 - No longer include qcom-ipq4019-ap.dk01.1.dtsi. This
   file is only partially upstream and therefore subjected
   to changes that might not be compatible with the board.

   As a result, the definitions from the file have been
   copied into this dts.

 - exclusively use decimal GPIO addresses.

 - reorganize the reserved-memory layout to waste less
   memory. There's no point in keeping the u-boot loader
   around. This should also make it possible    to create
   an image that will boot with the original EVA/ADAM2 loader
   without needing to install the modified u-boot loader.
   And finally mark the "tz-apps" as reusable.
   There isn't a way to  upload apps to the trust-zone in OpenWrt
   yet. But it might see some use in the future as a "secure"
   key-store/TPM.

 - sort the first-level nodes alphabetically.
 - sort nodes with an address by the address.

Signed-off-by: Christian Lamparter <chunkeey@gmail.com>
2018-01-18 21:21:11 +01:00
..
base-files ipq806x: fix ZyXEL NBG6817 sysupgrade 2018-01-18 07:22:37 +01:00
files-4.9/arch/arm/boot/dts ipq806x: overhaul AVM FRITZ!box 4040 device-tree file 2018-01-18 21:21:11 +01:00
image ipq806x: drop ubifs support 2018-01-15 21:45:43 +01:00
patches-4.9 ipq806x: usb: add phy 1 master reset control 2018-01-17 11:04:57 +01:00
profiles ipq806x: enable ath10k firmware for 988x, 99x0 and 9984 by default 2016-07-04 11:41:32 +02:00
config-4.9 ipq806x: enable gpio watchdog support 2018-01-13 08:00:07 +01:00
Makefile ipq806x: drop ubifs support 2018-01-15 21:45:43 +01:00
modules.mk Revert "ipq806x: make the dwc3 driver and required phy drivers built-in" 2017-03-23 08:29:44 +01:00