openwrtv4/target/linux
Steven Lin 2b4ac79a79 ipq40xx: add support for EnGenius EAP1300
SOC:    IPQ4018 / QCA Dakota
CPU:    Quad-Core ARMv7 Processor rev 5 (v7l) Cortex-A7
DRAM:   256 MiB
NOR:    32 MiB
ETH:    Qualcomm Atheros QCA8072
WLAN1:  Qualcomm Atheros QCA4018 2.4GHz 802.11bgn 2:2x2
WLAN2:  Qualcomm Atheros QCA4018 5GHz 802.11a/n/ac 2:2x2
INPUT:  RESET Button
LEDS:   Power, LAN, MESH, WLAN 2.4GHz, WLAN 5GHz

1. Load Ramdisk via U-Boot

To set up the flash memory environment, do the following:
a. As a preliminary step, ensure that the board console port is connected to the PC using these RS232 parameters:
   * 115200bps
   * 8N1
b. Confirm that the PC is connected to the board using one of the Ethernet ports. Set a static ip 192.168.99.8 for Ethernet that connects to board. The PC must have a TFTP server launched and listening on the interface to which the board is connected. At this stage power up the board and, after a few seconds, press 4 and then any key during the countdown.

U-BOOT> set serverip 192.168.99.8 && set ipaddr 192.168.99.9 && tftpboot 0x84000000 openwrt.itb && bootm

2. Load image via GUI

a. Upgrade EAP1300 to FW v3.5.3.2
In the GUI, System Manager > Firmware > Firmware Upgrade, to do upgrade.
b. Transfer to OpenWrt from EnGenius.
In Firmware Upgrade page, to upgrade yours openwrt-ipq40xx-engenius_eap1300-squashfs-sysupgrade.bin.

3. Revert to EnGenius EAP1300
To flash openwrt-ipq40xx-engenius_eap1300-squashfs-factory.bin by using sysupgrade command and "DO NOT" keep configuration.
$ sysupgrade –n openwrt-ipq40xx-engenius_eap1300-squashfs-factory.bin

Signed-off-by: Steven Lin <steven.lin@senao.com>
2018-12-05 09:40:32 +01:00
..
adm5120 kernel: bump 3.18 to 3.18.123 2018-09-26 15:54:18 +02:00
adm8668 treewide: use wpad-basic for not small flash targets 2018-10-16 15:07:41 +01:00
apm821xx apm821xx: wndr4700: restore sd-card media detection 2018-11-26 12:05:47 +01:00
ar7 treewide: use wpad-basic for not small flash targets 2018-10-16 15:07:41 +01:00
ar71xx ath79: modify mtd partitions for Buffalo BHR-4GRV2 2018-11-26 12:28:17 +01:00
arc770 treewide: use wpad-basic for not small flash targets 2018-10-16 15:07:41 +01:00
archs38 treewide: use wpad-basic for not small flash targets 2018-10-16 15:07:41 +01:00
armvirt kernel: bump 4.14 to 4.14.77 2018-10-19 10:01:57 +02:00
at91 kernel: enable memory compaction 2018-10-09 14:29:55 +02:00
ath25 kernel: bump 4.14 to 4.14.79 2018-11-05 16:00:00 +01:00
ath79 ath79: add support for Ubiquiti AirRouter 2018-12-03 07:58:56 +01:00
au1000 treewide: use wpad-basic for not small flash targets 2018-10-16 15:07:41 +01:00
bcm53xx bcm53xx: request Seama parser on DIR-885L directly 2018-11-22 10:13:56 +01:00
brcm47xx kernel: bump 4.14 to 4.14.81 2018-11-14 16:27:43 +01:00
brcm63xx kernel: bump 4.14 to 4.14.79 2018-11-05 16:00:00 +01:00
brcm2708 brcm2708-gpu-fw: add fw required for camera module 2018-12-05 00:39:53 +02:00
cns3xxx kernel: bump 4.14 to 4.14.77 2018-10-19 10:01:57 +02:00
gemini gemini: Fix up image generation 2018-10-20 16:13:39 +02:00
generic kernel: add missing symbol 2018-12-04 22:45:08 +02:00
imx6 imx6: image: ventana: Add missing BOOT_SCRIPT variable 2018-11-25 19:23:03 +01:00
ipq40xx ipq40xx: add support for EnGenius EAP1300 2018-12-05 09:40:32 +01:00
ipq806x ipq806x: Add support for IPQ8064 AP161 board 2018-11-26 12:05:46 +01:00
ixp4xx treewide: use wpad-basic for not small flash targets 2018-10-16 15:07:41 +01:00
kirkwood treewide: use wpad-basic for not small flash targets 2018-10-16 15:07:41 +01:00
lantiq lantiq: enable FXS ports on VR200v 2018-11-26 12:30:33 +01:00
layerscape kernel: bump 4.9 to 4.9.137 2018-11-14 16:27:43 +01:00
malta treewide: use wpad-basic for not small flash targets 2018-10-16 15:07:41 +01:00
mcs814x kernel: bump 3.18 to 3.18.119 2018-08-20 13:03:23 +02:00
mediatek kernel: bump 4.14 to 4.14.79 2018-11-05 16:00:00 +01:00
mpc85xx mpc85xx: workaround 4.14 cross compile issue 2018-10-20 16:24:29 +02:00
mvebu kernel: bump 4.14 to 4.14.81 2018-11-14 16:27:43 +01:00
mxs mxs: use generic sysinfo board detection 2018-11-28 23:37:29 +01:00
octeon octeon: remove linux 4.9 support 2018-09-29 18:09:45 +02:00
octeontx kernel: enable memory compaction 2018-10-09 14:29:55 +02:00
omap kernel: bump 4.14 to 4.14.77 2018-10-19 10:01:57 +02:00
omap24xx omap24xx: remove referece to not existing kmod-usb-musb-tusb6010 2018-01-15 13:13:34 +01:00
orion treewide: use wpad-basic for not small flash targets 2018-10-16 15:07:41 +01:00
oxnas oxnas: remove superseded sysupgrade image check 2018-11-08 14:41:42 +01:00
pistachio kernel: bump 4.14 to 4.14.79 2018-11-05 16:00:00 +01:00
ppc40x kernel: only optimized for size if small_flash 2018-07-12 18:15:32 +02:00
ppc44x kernel: only optimized for size if small_flash 2018-07-12 18:15:32 +02:00
ramips ramips: fix Netgear EX3700/EX3800 wireless driver selection 2018-12-04 20:40:27 +01:00
rb532 rb532: drop 4.9 support 2018-11-26 09:34:09 +01:00
samsung kernel: bump 4.14 to 4.14.77 2018-10-19 10:01:57 +02:00
sunxi kernel: bump 4.14 to 4.14.77 2018-10-19 10:01:57 +02:00
uml treewide: use wpad-basic for not small flash targets 2018-10-16 15:07:41 +01:00
x86 x86: make sysupgrade.tgz reachable again 2018-12-03 07:38:20 +01:00
xburst kernel: bump 3.18 to 3.18.119 2018-08-20 13:03:23 +02:00
zynq kernel: bump 4.14 to 4.14.77 2018-10-19 10:01:57 +02:00
Makefile