/dts-v1/; #include "mt7620a.dtsi" #include <dt-bindings/gpio/gpio.h> #include <dt-bindings/input/input.h> / { compatible = "phicomm,psg1208", "ralink,mt7620a-soc"; model = "Phicomm PSG1208"; gpio-leds { compatible = "gpio-leds"; wan { label = "psg1208:white:wps"; gpios = <&gpio1 15 GPIO_ACTIVE_LOW>; }; wlan { label = "psg1208:white:wlan2g"; gpios = <&gpio3 0 GPIO_ACTIVE_LOW>; }; }; gpio-keys-polled { compatible = "gpio-keys-polled"; #address-cells = <1>; #size-cells = <0>; poll-interval = <20>; reset { label = "reset"; gpios = <&gpio0 1 GPIO_ACTIVE_LOW>; linux,code = <KEY_RESTART>; }; }; }; &gpio1 { status = "okay"; }; &gpio3 { status = "okay"; }; &spi0 { status = "okay"; m25p80@0 { #address-cells = <1>; #size-cells = <1>; compatible = "jedec,spi-nor"; reg = <0>; spi-max-frequency = <10000000>; partition@0 { label = "u-boot"; reg = <0x0 0x30000>; read-only; }; partition@20000 { label = "u-boot-env"; reg = <0x30000 0x10000>; read-only; }; factory: partition@30000 { label = "factory"; reg = <0x40000 0x10000>; read-only; }; partition@40000 { label = "firmware"; reg = <0x50000 0x7b0000>; }; }; }; &pinctrl { state_default: pinctrl0 { gpio { ralink,group = "i2c", "spi refclk", "wled"; ralink,function = "gpio"; }; }; }; ðernet { pinctrl-names = "default"; pinctrl-0 = <&ephy_pins>; mtd-mac-address = <&factory 0x4>; mediatek,portmap = "llllw"; }; &pcie { status = "okay"; pcie-bridge { mt76@0,0 { reg = <0x0000 0 0 0 0>; device_type = "pci"; mediatek,mtd-eeprom = <&factory 0x8000>; ieee80211-freq-limit = <5000000 6000000>; }; }; }; &wmac { ralink,mtd-eeprom = <&factory 0>; };