openwrtv4/package/broadcom-57xx/src/bcmparams.h

/*
 * Misc system wide parameters.
 *
 * Copyright 2007, Broadcom Corporation
 * All Rights Reserved.
 * 
 * THIS SOFTWARE IS OFFERED "AS IS", AND BROADCOM GRANTS NO WARRANTIES OF ANY
 * KIND, EXPRESS OR IMPLIED, BY STATUTE, COMMUNICATION OR OTHERWISE. BROADCOM
 * SPECIFICALLY DISCLAIMS ANY IMPLIED WARRANTIES OF MERCHANTABILITY, FITNESS
 * FOR A SPECIFIC PURPOSE OR NONINFRINGEMENT CONCERNING THIS SOFTWARE.
 */

#ifndef	_bcmparams_h_
#define	_bcmparams_h_

#define VLAN_MAXVID	15	/* Max. VLAN ID supported/allowed */

#define VLAN_NUMPRIS	8	/* # of prio, start from 0 */

#define DEV_NUMIFS	16	/* Max. # of devices/interfaces supported */

#define WL_MAXBSSCFG	16	/* maximum number of BSS Configs we can configure */

#endif
(6/6) bcm57xx: package This is the bcm57xx package. I have tested default vlan functions, but I dont have the equipment to test more advanced setups. The default vlan setup seems to be working fine. I also added the activate_gpio parameter which will make the driver activate the switch via gpio before probing for it. I'm not sure which method is best for autoload. For the wrt350n, I need the activate_gpio parameter. But its probably not a good idea to add that to the autoload file. On a system without a bcm57xx switch, isn't it a bad idea to mess with the gpios looking for the switch? Ideally, wouldn't it be best to load the bcm57xx module from broadcom-diag, after it has determined which router its on? I tried using 'request_module' from there, but had no success. For now, I am relying on preinit to load the bcm57xx module with activate_gpio param, after it has failed to load switch_robo and switch_adm. Signed-off-by: Ben Pfountz <netprince (at) vt (dot) edu> SVN-Revision: 11471 2008-06-15 11:11:28 +00:00			`/*`
			`* Misc system wide parameters.`
			`*`
			`* Copyright 2007, Broadcom Corporation`
			`* All Rights Reserved.`
			`*`
			`* THIS SOFTWARE IS OFFERED "AS IS", AND BROADCOM GRANTS NO WARRANTIES OF ANY`
			`* KIND, EXPRESS OR IMPLIED, BY STATUTE, COMMUNICATION OR OTHERWISE. BROADCOM`
			`* SPECIFICALLY DISCLAIMS ANY IMPLIED WARRANTIES OF MERCHANTABILITY, FITNESS`
			`* FOR A SPECIFIC PURPOSE OR NONINFRINGEMENT CONCERNING THIS SOFTWARE.`
			`*/`

			`#ifndef _bcmparams_h_`
			`#define _bcmparams_h_`

			`#define VLAN_MAXVID 15 /* Max. VLAN ID supported/allowed */`

			`#define VLAN_NUMPRIS 8 /* # of prio, start from 0 */`

			`#define DEV_NUMIFS 16 /* Max. # of devices/interfaces supported */`

			`#define WL_MAXBSSCFG 16 /* maximum number of BSS Configs we can configure */`

			`#endif`