openwrtv4/target/linux/brcm63xx/patches-4.14/404-NET-bcm63xx_enet-move-phy_-dis-connect-into-probe-re.patch

From 7fa63fdde703aaabaa7199ae879219737a98a3f3 Mon Sep 17 00:00:00 2001
From: Jonas Gorski <jonas.gorski@gmail.com>
Date: Fri, 6 Jan 2012 12:24:18 +0100
Subject: [PATCH] NET: bcm63xx_enet: move phy_(dis)connect into probe/remove

Only connect/disconnect the phy during probe and remove, not during any
open/close. The phy seldom changes during the runtime, and disconnecting
the phy during close will prevent it from keeping any configuration over
a down/up cycle.

Signed-off-by: Jonas Gorski <jonas.gorski@gmail.com>
---
 drivers/net/ethernet/broadcom/bcm63xx_enet.c | 158 +++++++++++++--------------
 1 file changed, 78 insertions(+), 80 deletions(-)

--- a/drivers/net/ethernet/broadcom/bcm63xx_enet.c
+++ b/drivers/net/ethernet/broadcom/bcm63xx_enet.c
@@ -869,10 +869,8 @@ static int bcm_enet_open(struct net_devi
 	struct bcm_enet_priv *priv;
 	struct sockaddr addr;
 	struct device *kdev;
-	struct phy_device *phydev;
 	int i, ret;
 	unsigned int size;
-	char phy_id[MII_BUS_ID_SIZE + 3];
 	void *p;
 	u32 val;
 
@@ -880,40 +878,10 @@ static int bcm_enet_open(struct net_devi
 	kdev = &priv->pdev->dev;
 
 	if (priv->has_phy) {
-		/* connect to PHY */
-		snprintf(phy_id, sizeof(phy_id), PHY_ID_FMT,
-			 priv->mii_bus->id, priv->phy_id);
-
-		phydev = phy_connect(dev, phy_id, bcm_enet_adjust_phy_link,
-				     PHY_INTERFACE_MODE_MII);
-
-		if (IS_ERR(phydev)) {
-			dev_err(kdev, "could not attach to PHY\n");
-			return PTR_ERR(phydev);
-		}
-
-		/* mask with MAC supported features */
-		phydev->supported &= (SUPPORTED_10baseT_Half |
-				      SUPPORTED_10baseT_Full |
-				      SUPPORTED_100baseT_Half |
-				      SUPPORTED_100baseT_Full |
-				      SUPPORTED_Autoneg |
-				      SUPPORTED_Pause |
-				      SUPPORTED_MII);
-		phydev->advertising = phydev->supported;
-
-		if (priv->pause_auto && priv->pause_rx && priv->pause_tx)
-			phydev->advertising |= SUPPORTED_Pause;
-		else
-			phydev->advertising &= ~SUPPORTED_Pause;
-
-		phy_attached_info(phydev);
-
+		/* Reset state */
 		priv->old_link = 0;
 		priv->old_duplex = -1;
 		priv->old_pause = -1;
-	} else {
-		phydev = NULL;
 	}
 
 	/* mask all interrupts and request them */
@@ -923,7 +891,7 @@ static int bcm_enet_open(struct net_devi
 
 	ret = request_irq(dev->irq, bcm_enet_isr_mac, 0, dev->name, dev);
 	if (ret)
-		goto out_phy_disconnect;
+		return ret;
 
 	ret = request_irq(priv->irq_rx, bcm_enet_isr_dma, 0,
 			  dev->name, dev);
@@ -1085,8 +1053,8 @@ static int bcm_enet_open(struct net_devi
 	enet_dmac_writel(priv, priv->dma_chan_int_mask,
 			 ENETDMAC_IRMASK, priv->tx_chan);
 
-	if (phydev)
-		phy_start(phydev);
+	if (priv->has_phy)
+		phy_start(dev->phydev);
 	else
 		bcm_enet_adjust_link(dev);
 
@@ -1127,10 +1095,6 @@ out_freeirq_rx:
 out_freeirq:
 	free_irq(dev->irq, dev);
 
-out_phy_disconnect:
-	if (phydev)
-		phy_disconnect(phydev);
-
 	return ret;
 }
 
@@ -1235,10 +1199,6 @@ static int bcm_enet_stop(struct net_devi
 	free_irq(priv->irq_rx, dev);
 	free_irq(dev->irq, dev);
 
-	/* release phy */
-	if (priv->has_phy)
-		phy_disconnect(dev->phydev);
-
 	return 0;
 }
 
@@ -1804,14 +1764,49 @@ static int bcm_enet_probe(struct platfor
 
 	/* do minimal hardware init to be able to probe mii bus */
 	bcm_enet_hw_preinit(priv);
+	spin_lock_init(&priv->rx_lock);
+
+	/* init rx timeout (used for oom) */
+	init_timer(&priv->rx_timeout);
+	priv->rx_timeout.function = bcm_enet_refill_rx_timer;
+	priv->rx_timeout.data = (unsigned long)dev;
+
+	/* init the mib update lock&work */
+	mutex_init(&priv->mib_update_lock);
+	INIT_WORK(&priv->mib_update_task, bcm_enet_update_mib_counters_defer);
+
+	/* zero mib counters */
+	for (i = 0; i < ENET_MIB_REG_COUNT; i++)
+		enet_writel(priv, 0, ENET_MIB_REG(i));
+
+	/* register netdevice */
+	dev->netdev_ops = &bcm_enet_ops;
+	netif_napi_add(dev, &priv->napi, bcm_enet_poll, 16);
+
+	dev->ethtool_ops = &bcm_enet_ethtool_ops;
+	/* MTU range: 46 - 2028 */
+	dev->min_mtu = ETH_ZLEN - ETH_HLEN;
+	dev->max_mtu = BCMENET_MAX_MTU - VLAN_ETH_HLEN;
+	SET_NETDEV_DEV(dev, &pdev->dev);
+
+	ret = register_netdev(dev);
+	if (ret)
+		goto out_uninit_hw;
+
+	netif_carrier_off(dev);
+	platform_set_drvdata(pdev, dev);
+	priv->pdev = pdev;
+	priv->net_dev = dev;
 
 	/* MII bus registration */
 	if (priv->has_phy) {
+		struct phy_device *phydev;
+		char phy_id[MII_BUS_ID_SIZE + 3];
 
 		priv->mii_bus = mdiobus_alloc();
 		if (!priv->mii_bus) {
 			ret = -ENOMEM;
-			goto out_uninit_hw;
+			goto out_unregister_netdev;
 		}
 
 		bus = priv->mii_bus;
@@ -1835,6 +1830,35 @@ static int bcm_enet_probe(struct platfor
 			dev_err(&pdev->dev, "unable to register mdio bus\n");
 			goto out_free_mdio;
 		}
+
+		/* connect to PHY */
+		snprintf(phy_id, sizeof(phy_id), PHY_ID_FMT,
+			 priv->mii_bus->id, priv->phy_id);
+
+		phydev = phy_connect(dev, phy_id, bcm_enet_adjust_phy_link,
+				     PHY_INTERFACE_MODE_MII);
+
+		if (IS_ERR(phydev)) {
+			dev_err(&pdev->dev, "could not attach to PHY\n");
+			goto out_unregister_mdio;
+		}
+
+		/* mask with MAC supported features */
+		phydev->supported &= (SUPPORTED_10baseT_Half |
+				      SUPPORTED_10baseT_Full |
+				      SUPPORTED_100baseT_Half |
+				      SUPPORTED_100baseT_Full |
+				      SUPPORTED_Autoneg |
+				      SUPPORTED_Pause |
+				      SUPPORTED_MII);
+		phydev->advertising = phydev->supported;
+
+		if (priv->pause_auto && priv->pause_rx && priv->pause_tx)
+			phydev->advertising |= SUPPORTED_Pause;
+		else
+			phydev->advertising &= ~SUPPORTED_Pause;
+
+		phy_attached_info(phydev);
 	} else {
 
 		/* run platform code to initialize PHY device */
@@ -1842,47 +1866,16 @@ static int bcm_enet_probe(struct platfor
 		    pd->mii_config(dev, 1, bcm_enet_mdio_read_mii,
 				   bcm_enet_mdio_write_mii)) {
 			dev_err(&pdev->dev, "unable to configure mdio bus\n");
-			goto out_uninit_hw;
+			goto out_unregister_netdev;
 		}
 	}
 
-	spin_lock_init(&priv->rx_lock);
-
-	/* init rx timeout (used for oom) */
-	init_timer(&priv->rx_timeout);
-	priv->rx_timeout.function = bcm_enet_refill_rx_timer;
-	priv->rx_timeout.data = (unsigned long)dev;
-
-	/* init the mib update lock&work */
-	mutex_init(&priv->mib_update_lock);
-	INIT_WORK(&priv->mib_update_task, bcm_enet_update_mib_counters_defer);
-
-	/* zero mib counters */
-	for (i = 0; i < ENET_MIB_REG_COUNT; i++)
-		enet_writel(priv, 0, ENET_MIB_REG(i));
-
-	/* register netdevice */
-	dev->netdev_ops = &bcm_enet_ops;
-	netif_napi_add(dev, &priv->napi, bcm_enet_poll, 16);
-
-	dev->ethtool_ops = &bcm_enet_ethtool_ops;
-	/* MTU range: 46 - 2028 */
-	dev->min_mtu = ETH_ZLEN - ETH_HLEN;
-	dev->max_mtu = BCMENET_MAX_MTU - VLAN_ETH_HLEN;
-	SET_NETDEV_DEV(dev, &pdev->dev);
-
-	ret = register_netdev(dev);
-	if (ret)
-		goto out_unregister_mdio;
-
-	netif_carrier_off(dev);
-	platform_set_drvdata(pdev, dev);
-	priv->pdev = pdev;
-	priv->net_dev = dev;
-
 	return 0;
 
 out_unregister_mdio:
+	if (dev->phydev)
+		phy_disconnect(dev->phydev);
+
 	if (priv->mii_bus)
 		mdiobus_unregister(priv->mii_bus);
 
@@ -1890,6 +1883,9 @@ out_free_mdio:
 	if (priv->mii_bus)
 		mdiobus_free(priv->mii_bus);
 
+out_unregister_netdev:
+	unregister_netdev(dev);
+
 out_uninit_hw:
 	/* turn off mdc clock */
 	enet_writel(priv, 0, ENET_MIISC_REG);
@@ -1920,6 +1916,7 @@ static int bcm_enet_remove(struct platfo
 	enet_writel(priv, 0, ENET_MIISC_REG);
 
 	if (priv->has_phy) {
+		phy_disconnect(dev->phydev);
 		mdiobus_unregister(priv->mii_bus);
 		mdiobus_free(priv->mii_bus);
 	} else {