openwrtv4/target/linux/brcm2708/patches-4.4/0350-clk-bcm2835-Mark-GPIO-clocks-enabled-at-boot-as-crit.patch

From edb0177945936b14fe58662743f9e9d4eeba4b73 Mon Sep 17 00:00:00 2001
From: Eric Anholt <eric@anholt.net>
Date: Mon, 9 May 2016 17:28:18 -0700
Subject: [PATCH 350/381] clk: bcm2835: Mark GPIO clocks enabled at boot as
 critical.

These divide off of PLLD_PER and are used for the ethernet and wifi
PHYs source PLLs.  Neither of them is currently represented by a phy
device that would grab the clock for us.

This keeps other drivers from killing the networking PHYs when they
disable their own clocks and trigger PLLD_PER's refcount going to 0.

v2: Skip marking as critical if they aren't on at boot.

Signed-off-by: Eric Anholt <eric@anholt.net>
---
 drivers/clk/bcm/clk-bcm2835.c | 13 ++++++++++++-
 1 file changed, 12 insertions(+), 1 deletion(-)

--- a/drivers/clk/bcm/clk-bcm2835.c
+++ b/drivers/clk/bcm/clk-bcm2835.c
@@ -1250,6 +1250,15 @@ static struct clk *bcm2835_register_cloc
 	init.name = data->name;
 	init.flags = data->flags | CLK_IGNORE_UNUSED;
 
+	/*
+	 * Some GPIO clocks for ethernet/wifi PLLs are marked as
+	 * critical (since some platforms use them), but if the
+	 * firmware didn't have them turned on then they clearly
+	 * aren't actually critical.
+	 */
+	if ((cprman_read(cprman, data->ctl_reg) & CM_ENABLE) == 0)
+		init.flags &= ~CLK_IS_CRITICAL;
+
 	if (data->is_vpu_clock) {
 		init.ops = &bcm2835_vpu_clock_clk_ops;
 	} else {
@@ -1724,13 +1733,15 @@ static const struct bcm2835_clk_desc clk
 		.div_reg = CM_GP1DIV,
 		.int_bits = 12,
 		.frac_bits = 12,
+		.flags = CLK_IS_CRITICAL,
 		.is_mash_clock = true),
 	[BCM2835_CLOCK_GP2]	= REGISTER_PER_CLK(
 		.name = "gp2",
 		.ctl_reg = CM_GP2CTL,
 		.div_reg = CM_GP2DIV,
 		.int_bits = 12,
-		.frac_bits = 12),
+		.frac_bits = 12,
+		.flags = CLK_IS_CRITICAL),
 
 	/* HDMI state machine */
 	[BCM2835_CLOCK_HSM]	= REGISTER_PER_CLK(