openwrtv3/target/linux/ar71xx
Christian Mehlis dc4eae7a8c ar71xx: Compex WPJ563 support
Specification:
- SoC: Qualcomm Atheros QCA9563 (775 MHz, MIPS 74Kc)
- RAM: 128 MiB
- Storage: 16MB NOR flash
- Wireless: Built into QCA9563 (Dragonfly), PHY modes b/g/n, 3x3 MIMO
- Ethernet: 2x1G

Tested and working:
- ethernet / switch / lan / wan
- 2.4GHz SoC wifi
- PCIe
- leds
- buzzer

Ramload:
- tftpboot 0x84000000 lede-ar71xx-generic-wpj563-16M-initramfs-uImage.bin
- bootm 0x84000000

Install:
- tftpboot 0x80500000 lede-ar71xx-generic-wpj563-16M-squashfs-sysupgrade.bin
- erase 0x9f030000 +$filesize
- erase 0x9f680000 +1
- cp.b $fileaddr 0x9f030000 $filesize

Erasing 0x9f680000 is required because uboot defines
"bootcmd=bootm 0x9f680000 || bootm 0x9f030000", so it first tries to boot
the higher address. I think the 16 mb flash are intended to be used as
8+8mb for a fallback image. In my hardware only the lower address has a
bootable image. But to make sure future hardware will boot lede too, I
erase one block, so uboot will skip this address.

Signed-off-by: Christian Mehlis <christian@m3hlis.de>
2017-03-30 09:57:22 +02:00
..
base-files ar71xx: Compex WPJ563 support 2017-03-30 09:57:22 +02:00
files ar71xx: Compex WPJ563 support 2017-03-30 09:57:22 +02:00
generic switch to the new usbport LED trigger 2016-10-19 12:09:45 +02:00
image ar71xx: Compex WPJ563 support 2017-03-30 09:57:22 +02:00
mikrotik ar71xx: Compex WPJ563 support 2017-03-30 09:57:22 +02:00
nand ar71xx: Compex WPJ563 support 2017-03-30 09:57:22 +02:00
patches-4.4 kernel: update kernel 4.4 to 4.4.56 2017-03-26 12:23:12 +02:00
config-4.4 ar71xx: Compex WPJ563 support 2017-03-30 09:57:22 +02:00
Makefile build: remove mips16 feature flag from target makefiles 2017-01-24 13:15:01 +01:00
modules.mk ar71xx: add LED driver NU801 2015-12-11 15:04:57 +00:00