openwrtv3/target/linux/brcm63xx/patches-4.4/573-board_R5010UNv2.patch
Jonas Gorski 0127c480bb brcm63xx: Neufbox 6: fix switch by probing through DT
Probe the switch through DT instead of a platform device. This fixes
probe, as GPIO offsets are now properly accounted for.

Fixes the following issue:

[    0.802953] 8021q: 802.1Q VLAN Support v1.8
[    0.810518] rtl8366_smi: gpio_request failed for 18, err=-517

Signed-off-by: Jonas Gorski <jonas.gorski@gmail.com>
2017-02-09 14:30:44 +01:00

70 lines
1.6 KiB
Diff

--- a/arch/mips/bcm63xx/boards/board_bcm963xx.c
+++ b/arch/mips/bcm63xx/boards/board_bcm963xx.c
@@ -638,6 +638,51 @@ static struct board_info __initdata boar
},
},
};
+
+static struct board_info __initdata board_R5010UNV2 = {
+ .name = "96328ang",
+ .expected_cpu_id = 0x6328,
+
+ .has_uart0 = 1,
+ .has_pci = 1,
+ .use_fallback_sprom = 1,
+ .has_ohci0 = 1,
+ .has_ehci0 = 1,
+ .num_usbh_ports = 1,
+ .has_enetsw = 1,
+
+ .enetsw = {
+ .used_ports = {
+ [0] = {
+ .used = 1,
+ .phy_id = 1,
+ .name = "Port 1",
+ },
+ [1] = {
+ .used = 1,
+ .phy_id = 2,
+ .name = "Port 2",
+ },
+ [2] = {
+ .used = 1,
+ .phy_id = 3,
+ .name = "Port 3",
+ },
+ [3] = {
+ .used = 1,
+ .phy_id = 4,
+ .name = "Port 4",
+ },
+ },
+ },
+
+ .fallback_sprom = {
+ .type = SPROM_BCM43217,
+ .pci_bus = 1,
+ .pci_dev = 0,
+ },
+};
+
#endif /* CONFIG_BCM63XX_CPU_6328 */
/*
@@ -2416,6 +2461,7 @@ static const struct board_info __initcon
&board_A4001N1,
&board_dsl_274xb_f1,
&board_FAST2704V2,
+ &board_R5010UNV2,
#endif
#ifdef CONFIG_BCM63XX_CPU_6338
&board_96338gw,
@@ -2514,6 +2560,7 @@ static struct of_device_id const bcm963x
{ .compatible = "comtrend,ar-5381u", .data = &board_AR5381u, },
{ .compatible = "comtrend,ar-5387un", .data = &board_AR5387un, },
{ .compatible = "d-link,dsl-274xb-f", .data = &board_dsl_274xb_f1, },
+ { .compatible = "nucom,r5010unv2", .data = &board_R5010UNV2, },
{ .compatible = "sagem,f@st2704v2", .data = &board_FAST2704V2, },
#endif
#ifdef CONFIG_BCM63XX_CPU_6338