openwrtv3/target/linux/ath79
David Bauer 6476148034 ath79: add support for OCEDO Raccoon
This commit adds support for the OCEDO Raccoon

SOC:	Atheros AR9344
RAM:    128MB
FLASH:  16MiB
WLAN1:  AR9344 2.4 GHz 802.11bgn 2x2
WLAN2:  AR9382 5 GHz 802.11an 2x2
INPUT:  RESET button
LED:    Power, LAN, WiFi 2.4, WiFi 5
Serial: Header Next to Black metal shield
        Pinout is 3.3V - GND - TX - RX (Arrow Pad is 3.3V)
        The Serial setting is 115200-8-N-1.

	NOTE: The U-Boot won't boot with the serial attached.
	Boot the device without serial attached and attach it
	after 3 seconds.

Tested and working:
 - Ethernet
 - 2.4 GHz WiFi
 - 5 GHz WiFi
 - TFTP boot from ramdisk image
 - Installation via ramdisk image
 - OpenWRT sysupgrade
 - Buttons
 - LEDs

Installation seems to be possible only through booting an OpenWRT
ramdisk image.

Hold down the reset button while powering on the device. It will load a
ramdisk image named 'raccoon-uImage-initramfs-lzma.bin' from 192.168.100.8.

Note: depending on the present software, the device might also try to
pull a file called 'raccoon-uimage-factory'. Only the name differs, it
is still used as a ramdisk image.

Wait for the ramdisk image to boot. OpenWRT can be written to the flash
via sysupgrade or mtd.

Due to the flip-flop bootloader which we not (yet) support, you need to
set the partition the bootloader is selecting. It is possible from the
initramfs image with

 > fw_setenv bootcmd run bootcmd_1

Afterwards you can reboot the device.

Signed-off-by: David Bauer <mail@david-bauer.net>
2018-07-08 00:04:27 +02:00
..
base-files ath79: add support for OCEDO Raccoon 2018-07-08 00:04:27 +02:00
dts ath79: add support for OCEDO Raccoon 2018-07-08 00:04:27 +02:00
files ath79: drop mv88e6063 switch driver 2018-07-04 01:20:02 +02:00
generic ath79: disable unused drivers for tiny target 2018-07-07 21:07:40 +02:00
image ath79: add support for OCEDO Raccoon 2018-07-08 00:04:27 +02:00
nand ath79: add initial nand support for gl-ar300m 2018-06-18 20:29:38 +02:00
patches-4.14 treewide: gpio-export: add error handling 2018-06-28 18:39:57 +02:00
tiny ath79: optimize ath79 tiny target for size 2018-07-07 21:07:40 +02:00
config-4.14 ath79: disable unused drivers for tiny target 2018-07-07 21:07:40 +02:00
Makefile ath79: add initial nand support for gl-ar300m 2018-06-18 20:29:38 +02:00
modules.mk ath79: add new OF only target for QCA MIPS silicon 2018-05-07 08:06:51 +02:00