openwrtv3/target/linux/malta
Felix Fietkau faabe8e8e6 malta: make eth0 the wan interface by default
Many packages for OpenWrt currently assume that lan is the "internal"
side of the network map, e.g. if installed, dnsmasq will hand out DHCP
leases on lan, firewall will allow forwarding on lan.

While at it, also configure a lan interface if eth1 exists.

Signed-off-by: Yousong Zhou <yszhou4tech@gmail.com>

SVN-Revision: 47326
2015-10-31 09:30:57 +00:00
..
base-files/etc malta: make eth0 the wan interface by default 2015-10-31 09:30:57 +00:00
be build: unify mips target cflags 2013-09-26 17:53:14 +00:00
be64 build: unify mips target cflags 2013-09-26 17:53:14 +00:00
image build: Prevent more gzip timestamps 2015-07-14 09:57:45 +00:00
le build: unify mips target cflags 2013-09-26 17:53:14 +00:00
le64 build: unify mips target cflags 2013-09-26 17:53:14 +00:00
patches kernel: update 3.18 to 3.18.14 2015-05-21 19:32:46 +00:00
config-3.18 malta: disable the openwrt commandline hack 2015-08-30 12:18:05 +00:00
Makefile malta: use as a default type device 2015-10-31 09:30:37 +00:00
README malta: update README 2013-07-19 17:12:47 +00:00

This Malta target is intended to be used with the Qemu emulator. It can be used
to prototype an OpenWrt firmware for MIPS processors. One could also use it to
troubleshoot MIPS applications without access to real hardware.

To use the images built by OpenWrt with qemu, use the following commands:

For the little-endian image:
qemu-system-mipsel -kernel bin/malta/openwrt-malta-le-vmlinux-initramfs.elf -nographic -m 256

For the big-endian image:
qemu-system-mips -kernel bin/malta/openwrt-malta-be-vmlinux-initramfs.elf -nographic -m 256

and enjoy the system bootin.