openwrtv3/target
Jiawei Wang 9c500db896 ramips: fix used MAC addresses for Phicomm K2P
The factory partition of the Phicomm K2P contains two MAC addresses.
The lower MAC address is at offset 0xe006 and the higher one is at
offset 0xe000.

Use the lower MAC address as base mac-address which the switch driver
increments by one for the second (wan) vlan.

The MAC addresses are still inverted in contrast to the stock firmware
where the lower MAC address is used for wan. But at least the use of a
MAC address not intended/reserved for this particular board is fixed.

Signed-off-by: Jiawei Wang <me@jwang.link>
2017-09-15 07:14:29 +02:00
..
imagebuilder imagebuilder: don't rewrite package list output 2017-06-17 01:24:43 +02:00
linux ramips: fix used MAC addresses for Phicomm K2P 2017-09-15 07:14:29 +02:00
sdk build: get rid of host.mk 2017-02-26 13:31:44 +01:00
toolchain build: get rid of host.mk 2017-02-26 13:31:44 +01:00
Config.in kernel: allow selecting RTC drivers on targets without explicit RTC support 2017-05-02 14:33:58 +02:00
Makefile build: make <subdir>/install opt-in, use it for target/ only 2017-02-09 13:51:35 +01:00