openwrtv3/target/linux/ipq806x/patches-4.4
Ram Chandra Jangir 5e49c57956 ipq806x: Add support for linux-4.4
1)Changes

- Rebased the patches for linux-4.4.7
- Added patch to fix spi nor fifo and dma support
- Added patch to configure watchdog barktime

2)Testing

Tested on IPQ AP148 Board:
 a. NOR boot and NAND boot
 b. ethernet network and ath10k wifi
 c. ubi sysupgrade

UnTested
 dwc3 usb has not been validated on IPQ board(AP148)

3)Known Issues:
 Once we flash ubi image on AP148, and if we reset the board, uboot on
 first boot creates PEB and LEB for dynamic sized partitions, which is incorrect
 and not what linux expects which causes errors when trying to mount rootfs.
 In order to test this, we can use the below steps:
  a. Flash the ubi image on board and don't reset the board
  b. load the kernel fit image in RAM and boot from there.

Signed-off-by: Ram Chandra Jangir <rjangi@codeaurora.org>
2016-05-27 15:50:17 +02:00
..
020-add-ap148-bootargs.patch
021-add-ap148-partitions.patch
022-add-db149-dts.patch
023-ARM-dts-ipq806x-Disable-i2c-device-on-gsbi4.patch
024-ap148-add-memory-node.patch
033-ARM-qcom-add-SFPB-nodes-to-IPQ806x-dts.patch
036-ARM-qcom-add-SMEM-device-node-to-IPQ806x-dts.patch
037-mtd-add-SMEM-parser-for-QCOM-platforms.patch
100-usb-phy-Add-Qualcomm-DWC3-HS-SS-PHY-drivers.patch
101-ARM-qcom-add-USB-nodes-to-ipq806x-ap148.patch
110-DT-PCI-qcom-Document-PCIe-devicetree-bindings.patch
111-PCI-qcom-Add-Qualcomm-PCIe-controller-driver.patch
112-ARM-dts-qcom-add-pcie-nodes-to-ipq806x-platforms.patch
113-ARM-qcom-automatically-select-PCI_DOMAINS-if-PCI-is-.patch
114-pcie-add-ctlr-init.patch
115-add-pcie-aux-clk-dts.patch
126-add-rpm-to-ipq8064-dts.patch
133-ARM-Add-Krait-L2-register-accessor-functions.patch
134-clk-mux-Split-out-register-accessors-for-reuse.patch
135-clk-Avoid-sending-high-rates-to-downstream-clocks-du.patch
136-clk-Add-safe-switch-hook.patch
137-clk-qcom-Add-support-for-High-Frequency-PLLs-HFPLLs.patch
138-clk-qcom-Add-HFPLL-driver.patch
139-clk-qcom-Add-IPQ806X-s-HFPLLs.patch
140-clk-qcom-Add-support-for-Krait-clocks.patch
141-clk-qcom-Add-KPSS-ACC-GCC-driver.patch
142-clk-qcom-Add-Krait-clock-controller-driver.patch
143-cpufreq-Add-module-to-register-cpufreq-on-Krait-CPUs.patch
144-ARM-dts-qcom-Add-necessary-DT-data-for-Krait-cpufreq.patch
145-cpufreq-Add-a-cpufreq-krait-based-on-cpufre.patch
155-dt-bindings-qcom_adm-Fix-channel-specifiers.patch
156-dmaengine-Add-ADM-driver.patch
157-ARM-DT-ipq8064-Add-ADM-device-node.patch
161-mtd-nand-Create-a-BBT-flag-to-access-bad-block-markers-in-raw-mode.patch
162-mtd-nand-Qualcomm-NAND-controller-driver.patch
163-dt-bindings-qcom_nandc-Add-DT-bindings.patch
164-arm-qcom-dts-Add-NAND-controller-node-for-ipq806x.patch
165-arm-qcom-dts-Enable-NAND-node-on-IPQ8064-AP148-platform.patch
166-arch-qcom-dts-enable-qcom-smem-on-AP148-NAND.patch
300-arch-arm-force-ZRELADDR-on-arch-qcom.patch
302-mtd-qcom-smem-rename-rootfs-ubi.patch
707-ARM-dts-qcom-add-mdio-nodes-to-ap148-db149.patch
708-ARM-dts-qcom-add-gmac-nodes-to-ipq806x-platforms.patch
709-spi-qup-Fix-fifo-and-dma-support-for-IPQ806x.patch
710-watchdog-qcom-set-WDT_BARK_TIME-register-offset-to-o.patch
800-ARM-qcom-add-Netgear-Nighthawk-X4-R7500-device-tree.patch
801-ARM-qcom-add-Netgear-Nighthawk-X4-D7800-device-tree.patch