openwrtv3/target/linux/au1000/patches-2.6.32/004-state_led_phy_fix.patch
Florian Fainelli 746fdb8f6d add 2.6.32 support
SVN-Revision: 19492
2010-02-01 21:11:02 +00:00

31 lines
993 B
Diff

--- a/drivers/net/au1000_eth.c
+++ b/drivers/net/au1000_eth.c
@@ -166,6 +166,15 @@ struct au1000_private *au_macs[NUM_ETH_I
# undef AU1XXX_PHY1_IRQ
#endif
+#if defined(CONFIG_MIPS_MTX1)
+/*
+ * 4G MeshCube (MTX-1) board
+ * PHY is at address 31 on MAC0
+ * autodetect fails if not searched for highest address !
+ */
+# define AU1XXX_PHY_SEARCH_HIGHEST_ADDR
+#endif
+
#if defined(AU1XXX_PHY0_BUSID) && (AU1XXX_PHY0_BUSID > 0)
# error MAC0-associated PHY attached 2nd MACs MII bus not supported yet
#endif
@@ -483,6 +492,12 @@ static int mii_probe (struct net_device
aup->old_duplex = -1;
aup->phy_dev = phydev;
+#ifdef CONFIG_MIPS_MTX1
+ /* set up ethernet jack LEDs on the 4G MeshCube (MTX-1 board) */
+ printk(KERN_INFO "MTX-1 PHY: updating LED settings\n");
+ phy_write(phydev, 0x11, 0xff80);
+#endif
+
printk(KERN_INFO "%s: attached PHY driver [%s] "
"(mii_bus:phy_addr=%s, irq=%d)\n", dev->name,
phydev->drv->name, dev_name(&phydev->dev), phydev->irq);