openwrtv3/target/linux/generic/patches-3.13/726-phy_rtl8366.patch
Felix Fietkau 1cbf0fbcb4 ar8216: factor out AR8327/AR8337-specific driver code into ar8327.c
Move all AR8327/AR8337-specific driver code into a separate source file
ar8327.c and adjust patches so that ar8327.c is compiled if
CONFIG_AR8216_PHY is set.

Signed-off-by: Heiner Kallweit <hkallweit1@gmail.com>

SVN-Revision: 43845
2015-01-05 13:03:07 +00:00

45 lines
1.3 KiB
Diff

--- a/drivers/net/phy/Kconfig
+++ b/drivers/net/phy/Kconfig
@@ -231,6 +231,30 @@ config MDIO_BUS_MUX_MMIOREG
Currently, only 8-bit registers are supported.
+config RTL8366_SMI
+ tristate "Driver for the RTL8366 SMI interface"
+ depends on GPIOLIB
+ ---help---
+ This module implements the SMI interface protocol which is used
+ by some RTL8366 ethernet switch devices via the generic GPIO API.
+
+if RTL8366_SMI
+
+config RTL8366_SMI_DEBUG_FS
+ bool "RTL8366 SMI interface debugfs support"
+ depends on DEBUG_FS
+ default n
+
+config RTL8366S_PHY
+ tristate "Driver for the Realtek RTL8366S switch"
+ select SWCONFIG
+
+config RTL8366RB_PHY
+ tristate "Driver for the Realtek RTL8366RB switch"
+ select SWCONFIG
+
+endif # RTL8366_SMI
+
endif # PHYLIB
config MICREL_KS8995MA
--- a/drivers/net/phy/Makefile
+++ b/drivers/net/phy/Makefile
@@ -23,6 +23,9 @@ obj-$(CONFIG_IP17XX_PHY) += ip17xx.o
obj-$(CONFIG_REALTEK_PHY) += realtek.o
obj-$(CONFIG_AR8216_PHY) += ar8216.o ar8327.o
obj-$(CONFIG_RTL8306_PHY) += rtl8306.o
+obj-$(CONFIG_RTL8366_SMI) += rtl8366_smi.o
+obj-$(CONFIG_RTL8366S_PHY) += rtl8366s.o
+obj-$(CONFIG_RTL8366RB_PHY) += rtl8366rb.o
obj-$(CONFIG_LSI_ET1011C_PHY) += et1011c.o
obj-$(CONFIG_FIXED_PHY) += fixed.o
obj-$(CONFIG_MDIO_BITBANG) += mdio-bitbang.o