openwrtv3/target/linux/ar71xx/image
Steffen Weinreich 224e5f5efa ar71xx: Add support for Teltonika RUT900
Teltonika RUT900 is a Router with LTE dual SIM, WiFi, 4x Ethernet
ports, I/O, RS232, RS485, GPS.

The device ist based on a Atheros AR9344 rev 3,

Specifications:
- 560/450/225 MHz (CPU/DDR/AHB)
- 128 MB of RAM
- 16 MB of FLASH
- Serial Console header on a Card Board edge connector
- 4x 10/100 Mbps Ethernet (3x LAN, 1x WAN)
- 2.4 GHz Wifi
- 2x external, detachable Wifi antennas
- LTE Modem Huawei ME909u-521 (Also other Modem seen)
- 2x LTE antennas
- 1x GPS antenna
- 7x LED, 1x button
- 1x USB Connector
- 1x Serial RS232
- 1x Serial RS485
- 1x MicroSD Card

The GPL sources of the device are available at www.teltonika.lt/gpl/
and are based on OpenWRT Barrier Breaker (14.07)

Running from tftp:

The Router starts into the uboot Webupdater if the Button ist pressed
more than 3 seconds, if no Network cable is attached it starts the
uboot serial console, from there the router loads the firmware image
via tftpboot from 192.168.1.2:firmware.bin (the router has the
192.168.1.1). With bootm the loaded image will be booted.

Signed-off-by: Steffen Weinreich <steve@weinreich.org>
2017-05-18 14:47:53 +02:00
..
lzma-loader ar71xx/lzma-loader: fix O32 ABI conformance 2016-01-17 15:29:03 +00:00
generic.mk ar71xx: move Zbtlink ZBT-WE1526 to generic build target 2017-05-15 22:43:33 +02:00
legacy-devices.mk ar71xx: move Zbtlink ZBT-WE1526 to generic build target 2017-05-15 22:43:33 +02:00
legacy.mk ar71xx: move Zbtlink ZBT-WE1526 to generic build target 2017-05-15 22:43:33 +02:00
Makefile ar71xx: convert mikrotik routerboard support to UBI 2017-01-16 20:40:12 +01:00
mikrotik.mk ar71xx: enable nand-utils in the mikrotik subtarget to ensure it makes it to initramfs 2017-05-12 13:29:55 +02:00
nand.mk ar71xx: add support for Aerohive AP-121 2017-05-15 22:58:59 +02:00
tp-link.mk ar71xx: Add support for Teltonika RUT900 2017-05-18 14:47:53 +02:00
ubinize-nbg6716.ini ar71xx: nbg6716: Enable procd nand sysupgrage 2014-06-26 11:43:38 +00:00
ubinize-wndr4300.ini ar71xx: remove old jffs2 marker from image generation on nand targets 2014-06-24 18:14:18 +00:00
ubnt.mk ar71xx: add support for UniFi-AC-Mesh 2017-05-15 22:43:33 +02:00