openwrtv3/target/linux
Christian Lamparter 1cb406d019 ipq806x: add ipq4019 fritz4040 support
This patch adds support for AVM FRITZ!Box 4040.

hardware highlights:

SOC:	IPQ4018 / QCA Dakota
CPU:	Quad-Core ARMv7 Processor rev 5 (v7l) Cortex-A7
DRAM:	256 MiB Nanya NT5CC128M16IP
FLASH:	32 MiB MXIC MX25L25635FMI
ETH:	Qualcomm Atheros QCA8075 Gigabit Switch (4 x LAN, 1 x WAN)
USB:	1 x 3.0 (via Synopsys DesignWare DWC3 controller in the SoC)
	1 x 2.0 (via Synopsys DesignWare DWC3 controller in the SoC)
WLAN1:	Qualcomm Atheros QCA4018 2.4GHz 802.11bgn 2:2x2
WLAN2:	Qualcomm Atheros QCA4018 5GHz 802.11a/n/ac 2:2x2
INPUT:	one WLAN and one WPS button
LEDS:	Power, WAN/Internet, WIFI, INFO (red and amber) and LAN.
Serial:
	WARNING: The serial port needs a TTL/RS-232 v3.3 level converter!
        The Serial setting is 115200-8-N-1. The SoC's serial port is right
	next to the MXIC FLASH chip. The board has a unpopulated 1x4 0.1"
	header for it. Use a multimeter to figure out the pinout!

This board currently needs an additional u-boot image in order to boot
properly. Booting with EVA isn't possible ATM.

Install Procedure:
 0. It's highly recommended to connect to the serial port.
    The serial settings are listed above.
 1. install a u-boot image for AVM Fritz!Box 4040
    (see <https://github.com/chunkeey/FritzBox-4040-UBOOT/releases> and
    <https://github.com/chunkeey/FritzBox-4040-UBOOT/blob/master/upload-to-f4040.sh>)
 2. upload the initramfs.itb image via tftp (u-boot listens to
    192.168.1.1 - use binary transfer mode!)
 3. connect to the FB4040 and use sysupgrade sysupgrade.bin
    to install the image.

Works:
	- Switch and Ethernet (99%)
        - Buttons (WLAN, WPS)
        - FLASH (1 x 32MiB NOR Chip)
        - WLAN2G and WLAN5G
        - CPUFREQ scaling
        - PRNG
        - serial
        - Crypto Accelerator
        - sysupgrade (Read the flash instructions to avoid bricking)
        - full LEDE Install (Read the flash instructions to avoid bricking)
	- LEDs (Power, WAN, Info (red and amber), LAN)
          The LEDs are connected to the QCA8075 LED ports.
	  The AR40xx driver contains a gpio-controller to
	  handle these special "GPIOs".
        - USB Both 3.0 and 2.0 ports
        - many packages from other ARMv7 boards
          (This does include the RaspberryPi Model 2!)
        - ...

Not planned:
	- WAN<->LAN short-cut
	- Qualcomm Secure Execution Environment
        - ...

Signed-off-by: Christian Lamparter <chunkeey@googlemail.com>
Signed-off-by: John Crispin <john@phrozen.org>
2017-03-22 09:45:18 +01:00
..
adm5120 adm5120: mark the rb1xx subtarget as broken 2017-01-16 20:40:12 +01:00
adm8668 build: fix subtarget descriptions 2016-09-04 13:35:11 +02:00
apm821xx kernel: update kernel 4.4 to 4.4.53 2017-03-12 15:46:02 +01:00
ar7 ar7: diag.sh: use common status_led_* functions 2017-03-15 23:14:54 +01:00
ar71xx ar71xx: mikrotik: prepend "RouterBOARD" to machine name for NOR devices 2017-03-15 23:00:52 +01:00
arc770 arc770: only calculate entry point address when necessary 2017-02-21 16:10:30 +01:00
archs38 archs38: only calculate entry point address when necessary 2017-02-21 16:10:32 +01:00
arm64 Revert "arm64: boot-wrapper: Add mirror" 2016-12-22 21:08:17 +01:00
armvirt armvirt: add kernel config change missing from 0d44f0cb 2017-01-13 11:05:32 +01:00
at91 kernel: remove ubifs xz decompression support 2017-01-09 14:07:06 +01:00
ath25 kernel: backport MIPS changes introducing a separate IRQ stack 2017-01-15 18:25:54 +01:00
au1000 kernel: update kernel 3.18 to version 3.18.43 2016-10-24 20:25:14 +03:00
bcm53xx kernel: update bcma including recent changes for 4.12 2017-03-21 09:58:05 +01:00
brcm47xx kernel: update kernel 4.4 to 4.4.53 2017-03-12 15:46:02 +01:00
brcm63xx brcm63xx: diag.sh: use common status_led_blink_* functions 2017-03-15 23:15:19 +01:00
brcm2708 brcm2708: add kmod-drm-vc4 package 2017-03-21 23:44:24 +01:00
cns3xxx kernel: update kernel 4.9 to version 4.9.10 2017-02-16 00:46:23 +01:00
gemini gemini: rename config-default to config-4.4 2016-08-24 01:44:05 +03:00
generic kernel: fix builds with kmod-drm-vc4 and kmod-backlight enabled 2017-03-22 08:49:33 +01:00
imx6 imx6: add DSA driver for MV88E6176 switch 2017-03-12 15:06:52 +01:00
ipq806x ipq806x: add ipq4019 fritz4040 support 2017-03-22 09:45:18 +01:00
ixp4xx kernel: update kernel 4.4 to 4.4.53 2017-03-12 15:46:02 +01:00
kirkwood kirkwood: fix include in etc/board.d/02_network 2017-02-28 23:46:02 +01:00
lantiq lantiq: Shortcut non-pppoa interfaces in dsl_notify 2017-03-17 08:58:50 +01:00
layerscape kernel: update kernel 4.4 to 4.4.52 2017-03-03 18:17:47 +01:00
malta malta: restore "be" subtarget from being source-only 2017-03-05 16:34:17 +01:00
mcs814x kernel: remove kmod packages for bridge, stp, llc and 8021q 2017-02-09 14:49:34 +01:00
mediatek kernel: update kernel 4.9 to 4.9.14 2017-03-12 15:45:50 +01:00
mpc85xx kernel: remove DEVMEM/DEVKMEM platform overrides 2017-01-10 13:48:53 +01:00
mvebu kernel: update kernel 4.9 to 4.9.14 2017-03-12 15:45:50 +01:00
mxs mxs: enable nvmem support 2017-02-10 11:05:57 +01:00
octeon octeon: only copy sysupgrade file if present 2017-02-15 06:36:21 +01:00
omap omap: build various core drivers into the kernel instead of packaging them 2017-01-10 13:44:26 +01:00
omap24xx kernel: clean up usb gadget support 2016-09-15 13:11:21 +02:00
orion kernel: split up 980-arm_openwrt_machtypes.patch and move to target folders 2017-01-27 11:18:27 +01:00
oxnas oxnas: put u-boot images into image staging directory 2017-01-27 16:53:31 +01:00
ppc40x build: fix subtarget descriptions 2016-09-04 13:35:11 +02:00
ppc44x ppc44x: mark as broken 2017-01-10 12:49:34 +01:00
ramips ramips: clean kernel config symbol conflicts for MT7688 PWM 2017-03-20 08:17:34 +01:00
rb532 kernel: remove ubifs xz decompression support 2017-01-09 14:07:06 +01:00
sunxi build: get rid of host.mk 2017-02-26 13:31:44 +01:00
uml build: get rid of host.mk 2017-02-26 13:31:44 +01:00
x86 x86: image: drop duplicated copy of bzImage into vmlinuz 2017-03-16 11:28:33 +01:00
xburst kernel: remove kmod packages for bridge, stp, llc and 8021q 2017-02-09 14:49:34 +01:00
zynq build: get rid of host.mk 2017-02-26 13:31:44 +01:00
Makefile