openwrtv3/target/linux/lantiq/dts/FRITZ7320.dts
Mathias Kresin 18c64f41c7 treewide: fix button keys codes used in dts
Use keycodes that matches the intended use case based on the label.

Signed-off-by: Mathias Kresin <dev@kresin.me>
2016-11-27 15:34:23 +01:00

160 lines
2.9 KiB
Text

/dts-v1/;
#include "ar9.dtsi"
#include <dt-bindings/input/input.h>
/ {
model = "FRITZ7320 - 1&1 HomeServer";
chosen {
bootargs = "console=ttyLTQ0,115200 init=/etc/preinit";
};
aliases {
led-boot = &power;
led-failsafe = &power;
led-running = &power;
led-internet = &info_green;
led-dsl = &power;
led-wifi = &wlan;
};
memory@0 {
reg = <0x0 0x4000000>;
};
fpi@10000000 {
localbus@0 {
nor-boot@0 {
compatible = "lantiq,nor";
bank-width = <2>;
reg = <0 0x0 0x1000000>;
#address-cells = <1>;
#size-cells = <1>;
partitions {
compatible = "fixed-partitions";
#address-cells = <1>;
#size-cells = <1>;
ath9k_cal: partition@0 {
label = "urlader";
reg = <0x00000 0x20000>;
read-only;
};
partition@20000 {
label = "firmware";
reg = <0x20000 0xf60000>;
};
partition@f80000 {
label = "tffs (1)";
reg = <0xf80000 0x40000>;
read-only;
};
partition@fc0000 {
label = "tffs (2)";
reg = <0xfc0000 0x40000>;
read-only;
};
};
};
};
ath9k_eep {
compatible = "ath9k,eeprom";
ath,eep-flash = <&ath9k_cal 0x985>;
ath,device-id = /bits/ 16 <0xff1d 0x2d>;
ath,eep-endian;
ath,eep-swap;
};
gpio: pinmux@E100B10 {
pinctrl-names = "default";
pinctrl-0 = <&state_default>;
state_default: pinmux {
pci {
lantiq,groups = "gnt1", "req1", "req2", "req3", "req4", "gnt2", "gnt3", "gnt4";
lantiq,function = "pci";
};
pci-in {
lantiq,groups = "req1", "req2", "req3", "req4";
lantiq,output = <0>;
lantiq,open-drain = <1>;
lantiq,pull = <2>;
};
pci-out {
lantiq,groups = "gnt1", "gnt2", "gnt3", "gnt4";
lantiq,output = <1>;
lantiq,pull = <0>;
};
};
};
etop@E180000 {
phy-mode = "mii";
};
ifxhcd@E101000 {
status = "okay";
};
pci@E105400 {
status = "okay";
req-mask = <0xf>;
gpio-reset = <&gpio 21 GPIO_ACTIVE_HIGH>;
};
};
gpio-keys-polled {
compatible = "gpio-keys-polled";
#address-cells = <1>;
#size-cells = <0>;
poll-interval = <100>;
rfkill {
label = "rfkill";
gpios = <&gpio 1 GPIO_ACTIVE_LOW>;
linux,code = <KEY_RFKILL>;
};
dect {
label = "dect";
gpios = <&gpio 2 GPIO_ACTIVE_LOW>;
linux,code = <KEY_PHONE>;
};
};
gpio-leds {
compatible = "gpio-leds";
power: power {
label = "fritz7320:green:power";
gpios = <&gpio 44 GPIO_ACTIVE_LOW>;
default-state = "keep";
};
voice {
label = "fritz7320:green:fon";
gpios = <&gpio 47 GPIO_ACTIVE_LOW>;
};
dect {
label = "fritz7320:green:dect";
gpios = <&gpio 38 GPIO_ACTIVE_LOW>;
};
wlan: wlan {
label = "fritz7320:green:wlan";
gpios = <&gpio 37 GPIO_ACTIVE_LOW>;
};
info_green: info_green {
label = "fritz7320:green:info";
gpios = <&gpio 35 GPIO_ACTIVE_LOW>;
};
info_red {
label = "fritz7320:red:info";
gpios = <&gpio 45 GPIO_ACTIVE_LOW>;
};
};
};