From 60b81acd602496d9b929d680c78b387d06b80ed1 Mon Sep 17 00:00:00 2001 From: Felix Fietkau Date: Sun, 7 Sep 2014 09:45:32 +0000 Subject: [PATCH] ath79: dev-eth: Don't advertise 1gbit in link code word on ar9331 While the AR9331 has a gigabit MAC towards the internal switch, the integrated PHYs however are only 100-base-tx capable. The existing code however advertieses gigabit capability in the link status word. If you attach such a PHY to a gigabit capable switch on the remote end, with some probability it attempts to negotiate gigabit and fails, falling baco to the AR9331 assuming a 10mbit half-duplex link. This has been observed quite frequently with the Carambola2 and gigabit capable switches. In ath79_register_eth(), "pdata->has_gbit = 1;" is set unconditionally for both AR9331 ethernet ports. This is most likely wrong. Despite the two MAC IP cores being gigabit MACs, the MAC for eth1 is connected to a 100base-T PHY via MII. The has_gbit attribute is used in the ethernet driver to determine the supported link modes. So either pdata->has_gbit is not set to 1 anymore, or the ethernet driver needs to be modified to determine the advertised link code word on another criteria than pdata->has_gbit. This patch implements the former solution. Signed-off-by: Harald Welte SVN-Revision: 42432 --- target/linux/ar71xx/files/arch/mips/ath79/dev-eth.c | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-) diff --git a/target/linux/ar71xx/files/arch/mips/ath79/dev-eth.c b/target/linux/ar71xx/files/arch/mips/ath79/dev-eth.c index 227f16e4c2..f106e22731 100644 --- a/target/linux/ar71xx/files/arch/mips/ath79/dev-eth.c +++ b/target/linux/ar71xx/files/arch/mips/ath79/dev-eth.c @@ -940,13 +940,13 @@ void __init ath79_register_eth(unsigned int id) pdata->set_speed = ath79_set_speed_dummy; pdata->speed = SPEED_1000; + pdata->has_gbit = 1; pdata->duplex = DUPLEX_FULL; pdata->switch_data = &ath79_switch_data; ath79_switch_data.phy_poll_mask |= BIT(4); } - pdata->has_gbit = 1; pdata->is_ar724x = 1; if (!pdata->fifo_cfg1)