openwrtv3/package/mac80211/patches/800-b43-gpio-mask-module-option.patch

--- a/drivers/net/wireless/b43/b43.h
+++ b/drivers/net/wireless/b43/b43.h
@@ -720,6 +720,7 @@ struct b43_wldev {
 	bool qos_enabled;		/* TRUE, if QoS is used. */
 	bool hwcrypto_enabled;		/* TRUE, if HW crypto acceleration is enabled. */
 	bool use_pio;			/* TRUE if next init should use PIO */
+	int gpiomask;			/* GPIO LED mask as a module parameter */
 
 	/* PHY/Radio device. */
 	struct b43_phy phy;
--- a/drivers/net/wireless/b43/main.c
+++ b/drivers/net/wireless/b43/main.c
@@ -76,6 +76,11 @@ MODULE_FIRMWARE("b43/ucode16_mimo.fw");
 MODULE_FIRMWARE("b43/ucode5.fw");
 MODULE_FIRMWARE("b43/ucode9.fw");
 
+static int modparam_gpiomask = 0x000F;
+module_param_named(gpiomask, modparam_gpiomask, int, 0444);
+MODULE_PARM_DESC(gpiomask,
+         "GPIO mask for LED control (default 0x000F)");
+
 static int modparam_bad_frames_preempt;
 module_param_named(bad_frames_preempt, modparam_bad_frames_preempt, int, 0444);
 MODULE_PARM_DESC(bad_frames_preempt,
@@ -2560,10 +2565,10 @@ static int b43_gpio_init(struct b43_wlde
 		    & ~B43_MACCTL_GPOUTSMSK);
 
 	b43_write16(dev, B43_MMIO_GPIO_MASK, b43_read16(dev, B43_MMIO_GPIO_MASK)
-		    | 0x000F);
+		    | modparam_gpiomask);
 
 	mask = 0x0000001F;
-	set = 0x0000000F;
+	set = modparam_gpiomask;
 	if (dev->sdev->bus->chip_id == 0x4301) {
 		mask |= 0x0060;
 		set |= 0x0060;
@@ -5084,10 +5089,10 @@ static void b43_print_driverinfo(void)
 	feat_sdio = "S";
 #endif
 	printk(KERN_INFO "Broadcom 43xx driver loaded "
-	       "[ Features: %s%s%s%s%s, Firmware-ID: "
+	       "[ Features: %s%s%s%s%s, GPIO LED Mask: 0x%04x, Firmware-ID: "
 	       B43_SUPPORTED_FIRMWARE_ID " ]\n",
 	       feat_pci, feat_pcmcia, feat_nphy,
-	       feat_leds, feat_sdio);
+	       feat_leds, feat_sdio, modparam_gpiomask);
 }
 
 static int __init b43_init(void)