openwrtv3/target/linux/gemini/patches-4.14/0901-arm-dts-gemini-fix-ethernet-for-nas4220b.patch

70 lines
1.5 KiB
Diff
Raw Normal View History

gemini: add 4.14 support This adds the patches to get fairly complete Gemini support using kernel v4.14. It is mainly a backport of patches from kernel v4.16 with omissions of things like graphics that require substantial changes and will be better handled once we move to the v4.16 kernel proper. On top of this are some WIP patches for USB support. Tested on Raidsonic NAS4220B and D-link DNS-313. ChangeLog v4->v5: - Fix ethernet single gmac usecase - Fix USB reset (patch from Hans) - Fix Raidsonic ethernet skew delay - Fix kernel config (bridge, squashfs, jffs2, usb) - Disable second usb port on Raidsonic board until fotg210_hcd is fixed ChangeLog v3->v4: - Make sure to use tabs rather than spaces in base-files. - Use the dns313 image tool from the firmware-utils. - Break out the addition of the v4.14 patches and the removal of the v4.4 patches to separate (big) patches. ChangeLog v2->v3: - Update the kernel config as indicated by Hauke Martens: - Regenerate again after rebasing using kernel_oldconfig dropping a few optimization settings that are now generic - Drop CFG80211 stuff (module) - Drop CIFS stuff (module) - Drop MAC80211 (module) - Drop wireless drivers (module) - Enabled OverlayFS - Added proper DNS-313 boot image generation with the special file header tool. - Disable CMA in the kernel - Enable LZMA compression of the kernel - Consequently name the nas4220b images nas4220b - Update preinit MAC detection script to handle also DNS-313 - Add board.d/03_hdparm to set the disk to spin down after 1 minute by default, if we have the hdparm tool installed ChangeLog v1->v2: - Processed config through kernel_oldconfig - Processed patches through make target/linux/{clean,refresh} V=99 Signed-off-by: Linus Walleij <linus.walleij@linaro.org> Signed-off-by: Roman Yeryomin <roman@advem.lv>
2018-04-29 14:38:07 +00:00
--- a/arch/arm/boot/dts/gemini-nas4220b.dts
+++ b/arch/arm/boot/dts/gemini-nas4220b.dts
@@ -137,6 +137,47 @@
groups = "gpio1dgrp";
};
};
+ pinctrl-gmii {
+ mux {
+ function = "gmii";
+ groups = "gmii_gmac0_grp";
+ };
+ conf0 {
+ pins = "V8 GMAC0 RXDV", "T10 GMAC1 RXDV";
+ skew-delay = <0>;
+ };
+ conf1 {
+ pins = "Y7 GMAC0 RXC", "Y11 GMAC1 RXC";
+ skew-delay = <15>;
+ };
+ conf2 {
+ pins = "T8 GMAC0 TXEN", "W11 GMAC1 TXEN";
+ skew-delay = <7>;
+ };
+ conf3 {
+ pins = "U8 GMAC0 TXC";
+ skew-delay = <11>;
+ };
+ conf4 {
+ pins = "V11 GMAC1 TXC";
+ skew-delay = <10>;
+ };
+ conf5 {
+ pins = "W8 GMAC0 RXD0", "V9 GMAC0 RXD1",
+ "Y8 GMAC0 RXD2", "U9 GMAC0 RXD3",
+ "T7 GMAC0 TXD0", "U6 GMAC0 TXD1",
+ "V7 GMAC0 TXD2", "U7 GMAC0 TXD3",
+ "Y12 GMAC1 RXD0", "V12 GMAC1 RXD1",
+ "T11 GMAC1 RXD2", "W12 GMAC1 RXD3",
+ "U10 GMAC1 TXD0", "Y10 GMAC1 TXD1",
+ "W10 GMAC1 TXD2", "T9 GMAC1 TXD3";
+ skew-delay = <7>;
+ };
+ conf6 {
+ groups = "gmii_gmac0_grp";
+ drive-strength = <16>;
+ };
+ };
};
};
@@ -151,6 +192,18 @@
pinctrl-0 = <&gpio1_default_pins>;
};
+ ethernet@60000000 {
+ status = "okay";
+
+ gmac0: ethernet-port@0 {
+ phy-mode = "rgmii";
+ phy-handle = <&phy0>;
+ };
+ gmac1: ethernet-port@1 {
+ status = "disabled";
+ };
+ };
+
ata@63000000 {
status = "okay";
};