openwrtv3/package/kernel/mac80211/patches/300-pending_work.patch

311 lines
9.7 KiB
Diff
Raw Normal View History

commit c82552c5b0cb1735dbcbad78b1ffc6d3c212dc56
Author: Tim Harvey <tharvey@gateworks.com>
Date: Mon Apr 21 16:14:57 2014 -0700
ath9k: add a recv budget
Implement a recv budget so that in cases of high traffic we still allow other
taskets to get processed.
Without this, we can encounter a host of issues during high wireless traffic
reception depending on system load including rcu stall's detected (ARM),
soft lockups, failure to service critical tasks such as watchdog resets,
and triggering of the tx stuck tasklet.
The same thing was proposed previously by Ben:
http://www.spinics.net/lists/linux-wireless/msg112891.html
The only difference here is that I make sure only processed packets are counted
in the budget by checking at the end of the rx loop.
Signed-off-by: Tim Harvey <tharvey@gateworks.com>
Acked-by: Felix Fietkau <nbd@openwrt.org>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
commit 3a758134e66ca74a9df792616b5288b2fa2cfd7f
Author: Tim Harvey <tharvey@gateworks.com>
Date: Mon Apr 21 16:14:56 2014 -0700
ath9k: fix possible hang on flush
If a flush is requested, make sure to clear the descriptor once we've
processed it.
This resolves a hang that will occur if all RX descriptors are full when a
flush is requested.
Signed-off-by: Tim Harvey <tharvey@gateworks.com>
Acked-by: Felix Fietkau <nbd@openwrt.org>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
commit eefb1d6adc4c60d219182b8917e4567484ce07fc
Author: Felix Fietkau <nbd@openwrt.org>
Date: Mon Apr 28 18:27:41 2014 +0200
ath9k: remove tid->paused flag
There are some corner cases where the driver could get stuck with a full
tid queue that is paused, leading to a software tx queue hang.
Since the tx queueing rework, pausing per-tid queues on aggregation
session setup is no longer necessary. The driver will assign sequence
numbers to buffered frames when a new session is established, in order
to get the correct starting sequence number.
mac80211 prevents new frames from entering the queue during setup.
Signed-off-by: Felix Fietkau <nbd@openwrt.org>
commit 98a713933d8495f4078f561c1e651b738dd5b531
Author: Felix Fietkau <nbd@openwrt.org>
Date: Sun Apr 27 14:49:03 2014 +0200
ath9k_hw: do not lower ANI setting below default on AR913x
When the amount of noise fluctuates strongly, low immunity settings
can sometimes disrupt signal detection on AR913x chips. When that
happens, no OFDM/CCK errors are reported anymore, and ANI tunes the
radio to the lowest immunity settings.
Usually rx/tx fails as well in that case.
To fix this, keep noise immunity settings at or above ANI default level,
which will keep radio parameters at or above INI values.
Signed-off-by: Felix Fietkau <nbd@openwrt.org>
commit 7cbb4c021bfd1e656f5b9953a947ab3c64e4e3b0
Author: Felix Fietkau <nbd@openwrt.org>
Date: Thu Apr 10 10:49:01 2014 +0200
mac80211: exclude AP_VLAN interfaces from tx power calculation
Their power value is initialized to zero. This patch fixes an issue
where the configured power drops to the minimum value when AP_VLAN
interfaces are created/removed.
Cc: stable@vger.kernel.org
Signed-off-by: Felix Fietkau <nbd@openwrt.org>
commit 0ca13e26341733bf9577287fb04a3bef0d2f5cc9
Author: Felix Fietkau <nbd@openwrt.org>
Date: Wed Apr 9 00:07:01 2014 +0200
mac80211: suppress BSS info change notifications for AP_VLAN
Fixes warnings on tx power changes
Signed-off-by: Felix Fietkau <nbd@openwrt.org>
commit ec998e5991781ecdaad0911dc64f1c8d3749c308
Author: Felix Fietkau <nbd@openwrt.org>
Date: Tue Apr 8 23:42:17 2014 +0200
ath9k: fix a scheduling while atomic bug in CSA handling
Commit "ath9k: prepare for multi-interface CSA support" added a call to
ieee80211_iterate_active_interfaces in atomic context (beacon tasklet),
which is crashing.
Use ieee80211_iterate_active_interfaces_atomic instead.
Signed-off-by: Felix Fietkau <nbd@openwrt.org>
commit 93f310a38a1d81a4bc8fcd9bf29628bd721cf2ef
Author: Felix Fietkau <nbd@openwrt.org>
Date: Sun Apr 6 23:35:28 2014 +0200
ath9k_hw: reduce ANI firstep range for older chips
Use 0-8 instead of 0-16, which is closer to the old implementation.
Also drop the overwrite of the firstep_low parameter to improve
stability.
Signed-off-by: Felix Fietkau <nbd@openwrt.org>
--- a/drivers/net/wireless/ath/ath9k/ar5008_phy.c
+++ b/drivers/net/wireless/ath/ath9k/ar5008_phy.c
@@ -1004,11 +1004,9 @@ static bool ar5008_hw_ani_control_new(st
case ATH9K_ANI_FIRSTEP_LEVEL:{
u32 level = param;
- value = level * 2;
+ value = level;
REG_RMW_FIELD(ah, AR_PHY_FIND_SIG,
AR_PHY_FIND_SIG_FIRSTEP, value);
- REG_RMW_FIELD(ah, AR_PHY_FIND_SIG_LOW,
- AR_PHY_FIND_SIG_FIRSTEP_LOW, value);
if (level != aniState->firstepLevel) {
ath_dbg(common, ANI,
--- a/drivers/net/wireless/ath/ath9k/beacon.c
+++ b/drivers/net/wireless/ath/ath9k/beacon.c
@@ -312,10 +312,9 @@ static void ath9k_csa_update_vif(void *d
void ath9k_csa_update(struct ath_softc *sc)
{
- ieee80211_iterate_active_interfaces(sc->hw,
- IEEE80211_IFACE_ITER_NORMAL,
- ath9k_csa_update_vif,
- sc);
+ ieee80211_iterate_active_interfaces_atomic(sc->hw,
+ IEEE80211_IFACE_ITER_NORMAL,
+ ath9k_csa_update_vif, sc);
}
void ath9k_beacon_tasklet(unsigned long data)
--- a/net/mac80211/main.c
+++ b/net/mac80211/main.c
@@ -152,6 +152,8 @@ static u32 ieee80211_hw_conf_chan(struct
list_for_each_entry_rcu(sdata, &local->interfaces, list) {
if (!rcu_access_pointer(sdata->vif.chanctx_conf))
continue;
+ if (sdata->vif.type == NL80211_IFTYPE_AP_VLAN)
+ continue;
power = min(power, sdata->vif.bss_conf.txpower);
}
rcu_read_unlock();
@@ -203,7 +205,7 @@ void ieee80211_bss_info_change_notify(st
{
struct ieee80211_local *local = sdata->local;
- if (!changed)
+ if (!changed || sdata->vif.type == NL80211_IFTYPE_AP_VLAN)
return;
drv_bss_info_changed(local, sdata, &sdata->vif.bss_conf, changed);
--- a/drivers/net/wireless/ath/ath9k/ani.c
+++ b/drivers/net/wireless/ath/ath9k/ani.c
@@ -155,6 +155,9 @@ static void ath9k_hw_set_ofdm_nil(struct
ATH9K_ANI_RSSI_THR_LOW,
ATH9K_ANI_RSSI_THR_HIGH);
+ if (AR_SREV_9100(ah) && immunityLevel < ATH9K_ANI_OFDM_DEF_LEVEL)
+ immunityLevel = ATH9K_ANI_OFDM_DEF_LEVEL;
+
if (!scan)
aniState->ofdmNoiseImmunityLevel = immunityLevel;
@@ -235,6 +238,9 @@ static void ath9k_hw_set_cck_nil(struct
BEACON_RSSI(ah), ATH9K_ANI_RSSI_THR_LOW,
ATH9K_ANI_RSSI_THR_HIGH);
+ if (AR_SREV_9100(ah) && immunityLevel < ATH9K_ANI_CCK_DEF_LEVEL)
+ immunityLevel = ATH9K_ANI_CCK_DEF_LEVEL;
+
if (ah->opmode == NL80211_IFTYPE_STATION &&
BEACON_RSSI(ah) <= ATH9K_ANI_RSSI_THR_LOW &&
immunityLevel > ATH9K_ANI_CCK_MAX_LEVEL_LOW_RSSI)
--- a/drivers/net/wireless/ath/ath9k/ath9k.h
+++ b/drivers/net/wireless/ath/ath9k/ath9k.h
@@ -251,7 +251,6 @@ struct ath_atx_tid {
s8 bar_index;
bool sched;
- bool paused;
bool active;
};
--- a/drivers/net/wireless/ath/ath9k/xmit.c
+++ b/drivers/net/wireless/ath/ath9k/xmit.c
@@ -107,9 +107,6 @@ static void ath_tx_queue_tid(struct ath_
{
struct ath_atx_ac *ac = tid->ac;
- if (tid->paused)
- return;
-
if (tid->sched)
return;
@@ -1407,7 +1404,6 @@ int ath_tx_aggr_start(struct ath_softc *
ath_tx_tid_change_state(sc, txtid);
txtid->active = true;
- txtid->paused = true;
*ssn = txtid->seq_start = txtid->seq_next;
txtid->bar_index = -1;
@@ -1427,7 +1423,6 @@ void ath_tx_aggr_stop(struct ath_softc *
ath_txq_lock(sc, txq);
txtid->active = false;
- txtid->paused = false;
ath_tx_flush_tid(sc, txtid);
ath_tx_tid_change_state(sc, txtid);
ath_txq_unlock_complete(sc, txq);
@@ -1487,7 +1482,7 @@ void ath_tx_aggr_wakeup(struct ath_softc
ath_txq_lock(sc, txq);
ac->clear_ps_filter = true;
- if (!tid->paused && ath_tid_has_buffered(tid)) {
+ if (ath_tid_has_buffered(tid)) {
ath_tx_queue_tid(txq, tid);
ath_txq_schedule(sc, txq);
}
@@ -1510,7 +1505,6 @@ void ath_tx_aggr_resume(struct ath_softc
ath_txq_lock(sc, txq);
tid->baw_size = IEEE80211_MIN_AMPDU_BUF << sta->ht_cap.ampdu_factor;
- tid->paused = false;
if (ath_tid_has_buffered(tid)) {
ath_tx_queue_tid(txq, tid);
@@ -1544,8 +1538,6 @@ void ath9k_release_buffered_frames(struc
continue;
tid = ATH_AN_2_TID(an, i);
- if (tid->paused)
- continue;
ath_txq_lock(sc, tid->ac->txq);
while (nframes > 0) {
@@ -1844,9 +1836,6 @@ void ath_txq_schedule(struct ath_softc *
list_del(&tid->list);
tid->sched = false;
- if (tid->paused)
- continue;
-
if (ath_tx_sched_aggr(sc, txq, tid, &stop))
sent = true;
@@ -2698,7 +2687,6 @@ void ath_tx_node_init(struct ath_softc *
tid->baw_size = WME_MAX_BA;
tid->baw_head = tid->baw_tail = 0;
tid->sched = false;
- tid->paused = false;
tid->active = false;
__skb_queue_head_init(&tid->buf_q);
__skb_queue_head_init(&tid->retry_q);
--- a/drivers/net/wireless/ath/ath9k/recv.c
+++ b/drivers/net/wireless/ath/ath9k/recv.c
@@ -975,6 +975,7 @@ int ath_rx_tasklet(struct ath_softc *sc,
u64 tsf = 0;
unsigned long flags;
dma_addr_t new_buf_addr;
+ unsigned int budget = 512;
if (edma)
dma_type = DMA_BIDIRECTIONAL;
@@ -1113,15 +1114,17 @@ requeue_drop_frag:
}
requeue:
list_add_tail(&bf->list, &sc->rx.rxbuf);
- if (flush)
- continue;
if (edma) {
ath_rx_edma_buf_link(sc, qtype);
} else {
ath_rx_buf_relink(sc, bf);
- ath9k_hw_rxena(ah);
+ if (!flush)
+ ath9k_hw_rxena(ah);
}
+
+ if (!budget--)
+ break;
} while (1);
if (!(ah->imask & ATH9K_INT_RXEOL)) {